28mm Wild West Wind Pump
B28-OW-102
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
To start, remove two of the uprights and the base Glue these to the base and at the same time, clip the
from the sprue.
sides together using the lugs provided.
Attach the other two sides the same way, Insert the shaft so it sits in the central hole in the base,
ensuring the lugs fit into the holes in the piece on then glue the platform into position (with the shaft
the right each time.
sticking through it) as shown above. The lugs on the
sides should fit snugly into the holes on the platform.
The tail is made by glueing the one of the square
pieces either side of the slot (see next pic).
Glue the tail onto the top of the shaft as shown above.
Finally glue the sails onto the end of the tail
piece. For added strength, also pop a bit of glue
where the sails touch the platform.