Bills of Quantities for Electrical Installation Works
Item
ELECTRICAL SERVICES -SASRA OFFICES
Description
Qty
Unit
300
80
20
No.
No.
No.
40
10
8
4
4
No.
No.
No.
No.
No.
8
No.
20
No.
20
No.
100
No.
Rate
Kshs
Cost Kshs
EIGHTEEN FLOOR
A
B
C
D
SUPPLY, DELIVER, INSTALL, TEST AND
COMMISSION THE FOLLOWING:LIGHTING POINTS
Lighting points wired in 3x1.5mm2 sc pvc copper cables
drawn in 20mm diameter heavy gauge pvc conduits
conceled in building fabric including all accessories but
without lighting switches and fittings for:
i) One way switching
ii) Two way switching
iii) Two way with intermediate switching
SWITCHES
10A, moulded plastic ivory white switch plates as Crabtree
or approved equivalent as follows:i) One gang one way
ii) Two gang one way
iii) One gang two way
iv) Two gang two way
v) Intermediate
10A, moulded ivory white architrave switch plates as MK
Range or approved equivalent as follows:i) One gang one way
LIGHT FITTINGS
Lighting fittings complete with lamps of appropriate
wattage and colour rendering and fixing materials as
follows:i) 1200mm, 1x36W IP65 rated dust and moisture resistant
flourescent fitting with injection moulded GRP Canopy
and Polycarbonate diffuser and stainless steel toggles as
THORN IMPACT RESIST
ii) 1200mm, 2x36W IP65 rated dust and moisture resistant
flourescent fitting with injection moulded GRP Canopy
and Polycarbonate diffuser and stainless steel toggles as
THORN IMPACT RESIST
iii) Circular Surface Luminaire fitting with Polycarbonate
Body and trim and opal diffuser and control gear for 28W
2D lamps as THORN Club CAT No. or Approved
Equivalent
0
Sub total C/F to the Next page
H/3
Bills of Quantities for Electrical Installation Works
Item
A
B
C
D
Description
Sub total B/F fro the previous page
iv) 600X600MM, 4X18W Recessed Modular flourescent
fitting for use in Standard Concealed Fix with low
brightness louvres as THORN QUATRO LINE or
Approved Equivalent
Self-contained single sided EXIT sign with 8W fluorescent
lamp for non-maintained emergency lighting for 3 hour
duration as Thorn EF X3 or approved equivalent.
POWER POINTS
Raw power socket outlet power points comprising wiring
in 3 x 4mm2 PVC/SC CU cables drawn in 25mmØ
concealed HG PVC conduits/trunking including all conduit
accessories but excluding plates
SOCKETS
13A moulded switched socket outlet plates as Crabtree or
approved equivalent as follows:
i) Single switched
ii) Twin switched
Hand drier power points comprising wiring in 3 x 4mm2
PVC/SC/CU cables drawn in 25mmØ HG/PVC conduits
complete with all necessary accessories
Qty
Unit
260
No.
4
No.
300
No.
40
250
4
No.
No.
No.
20A, DP control switch with neon light and cord outlet for
item above as Crabtree or approved equivalent
14
No.
E
Floor mounted pedestal for workstations capable of
accomodating 4No. Data/Telephone points & 4No. Twin
switched
socketsemi-circular
outlet points profile
fabricated
and
finished to
Floor
mounted
metal
trunking
complete with all accessories As Manufactured by Power
Technics
100 X 50mm Deep Powder coated metal trunking
complete with bends As Manufactured by Power Technics
Air Conditioning Unit power point comprising wiring in 5
x 10mm2 PVC/SC/CU cables drawn in Trunking/50mmØ
concealed HG PVC conduits
32A TPN Isolator switch for item No 2.16 above as
Crabtree or approved equivalent
10
No.
100
LM
150
LM
7
No.
7
No.
G
H
L
Cost Kshs
0
G
F
Rate
Kshs
0
Sub total C/F to the Next page
H/4
Bills of Quantities for Electrical Installation Works
Item
A
B
C
D
E
Description
Qty
Sub total B/F fro the previous page
Horizontal Data Cabling
48 port RJ45 cat 6 data patch panel for UTP termination as
2
No.
Siemons B1:B15 or approved equivalent.
1M RJ45-RJ45 Cat 6 UTP factory terminated patch cord as 120
No.
Siemons or approved equivalent to be used in cabinet.
Cable manager
6
No.
Cat 6 UTP 4-pair cable as Siemons or approved equivalent 12,240 M
.
3M RJ45-RJ45 Cat 6 UTP factory terminated patch cord as 120
No.
Siemons or approved equivalent to be used at work station.
F
RJ45 Cat 6 UTP (Dual) outlet complete with faceplate and
labeling system as Siemons or approved equivalent.
Active Components
G 48 port CISCO Switch, as described in particular
specifications.
H 250mm x 50mm deep two compartment metal
trunking constructed from heavy gauge powder coated
steel, and shall be complete with all accessories for 2
coupling and earthing including all trunking accessories.
I Supply, install, test and commission an IP PABX
equipped as specified in section ‘‘F’.’
J Supply, install, test and commission a battery set for the
E.P.A.B.X. above with enough capacity to serve all
auxiliary equipment linked to the E.PA.B.X. for a period of
minimum 8 hours .
K Supply, install, test and commission an AC Voltage
stabilizer for the E.P.A.B.X. and all auxiliary equipment.
Connected to the E.P.A.B.X
L Provide and independent telecommunication earth to the
E.P.A.B.X and MDF
M Supply, Install, Test and commision an MDF suitable for
the ultimate size of the EPABX Machine above
N Supply, Install, Test and commision a Modem for ISDN
PRI for the PABX
P Supply, install, test and commission Cisco 7942 unified IP
phone complete with telephone cord and termination block
as described in the technical Specifications section F
Q
Unit
Allow for terminating, testing and Labeling all voice
circuits.
Sub total C/F to the Next page
H/5
120
No.
3
No.
200
Lm
1
No.
1
No.
1
No.
1
No.
1
No.
1
No.
20
No.
1
Item
Rate
Kshs
Cost Kshs
Bills of Quantities for Electrical Installation Works
Item
Description
Sub total B/F fro the previous page
NINENTEEN FLOOR
SUPPLY, DELIVER, INSTALL, TEST AND
COMMISSION THE FOLLOWING:LIGHTING POINTS
A Lighting points wired in 3x1.5mm2 sc pvc copper cables
drawn in 20mm diameter heavy gauge pvc conduits
conceled in building fabric including all accessories but
without lighting switches and fittings for:
i) One way switching
ii) Two way switching
iii) Two way with intermediate switching
SWITCHES
B. 10A, moulded plastic ivory white switch plates as Crabtree
or approved equivalent as follows:i) One gang one way
ii) Two gang one way
iii) One gang two way
iv) Two gang two way
v) Intermediate
C 10A, moulded ivory white architrave switch plates as MK
Range or approved equivalent as follows:i) One gang one way
LIGHT FITTINGS
D
Lighting fittings complete with lamps of appropriate
wattage and colour rendering and fixing materials as
follows:i) 1200mm, 1x36W IP65 rated dust and moisture resistant
flourescent fitting with injection moulded GRP Canopy
and Polycarbonate diffuser and stainless steel toggles as
THORN IMPACT RESIST
ii) 1200mm, 2x36W IP65 rated dust and moisture resistant
flourescent fitting with injection moulded GRP Canopy
and Polycarbonate diffuser and stainless steel toggles as
THORN IMPACT RESIST
iii) Circular Surface Luminaire fitting with Polycarbonate
Body and trim and opal diffuser and control gear for 28W
2D lamps as THORN Club CAT No. or Approved
Equivalent
iv) 600X600MM, 4X18W Recessed Modular flourescent
fitting for use in Standard Concealed Fix with low
brightness louvres as THORN QUATRO LINE or
Approved Equivalent
Sub total C/F to the Next page
H/6
Qty
Unit
250
40
10
No.
No.
No.
40
10
8
4
4
No.
No.
No.
No.
No.
8
No.
10
No.
10
No.
50
No.
230
No.
Rate
Kshs
Cost Kshs
Bills of Quantities for Electrical Installation Works
Item
A
B
C
D
E
F
G
Description
Sub total B/F fro the previous page
Self-contained single sided EXIT sign with 8W fluorescent
lamp for non-maintained emergency lighting for 3 hour
duration as Thorn EF X3 or approved equivalent.
POWER POINTS
Raw power socket outlet power points comprising wiring
in 3 x 4mm2 PVC/SC CU cables drawn in 25mmØ
concealed HG PVC conduits/trunking including all conduit
accessories but excluding plates
SOCKETS
13A moulded switched socket outlet plates as Crabtree or
approved equivalent as follows:
i) Single switched
ii) Twin switched
Hand drier power points comprising wiring in 3 x 4mm2
PVC/SC/CU cables drawn in 25mmØ HG/PVC conduits
complete with all necessary accessories
20A, DP control switch with neon light and cord outlet for
item above as Crabtree or approved equivalent
Floor mounted pedestal for workstations capable of
accomodating 4No. Data/Telephone points & 4No. Twin
switched socket outlet points fabricated and finished to
engineers specifications.
Floor mounted semi-circular profile metal trunking
complete with all accessories As Manufactured by Power
Technics
H
100 X 50mm Deep Powder coated metal trunking
complete with bends As Manufactured by Power Technics
I Air Conditioning Unit power point comprising wiring in 5
x 10mm2 PVC/SC/CU cables drawn in Trunking/50mmØ
concealed HG PVC conduits
J 32A TPN Isolator switch for item No 2.16 above as
Crabtree or approved equivalent
Horizontal Data Cabling
K 48 port RJ45 cat 6 data patch panel for UTP termination as
Siemons B1:B15 or approved equivalent.
L 1M RJ45-RJ45 Cat 6 UTP factory terminated patch cord as
Siemons or approved equivalent to be used in cabinet.
M 42U cabinet
Sub total C/F to the Next page
H/7
Qty
Unit
4
No.
200
No.
40
160
4
No.
No.
No.
14
No.
10
No.
200
LM
200
LM
7
No.
7
No.
2
No.
120
No.
2
No.
Rate
Kshs
Cost Kshs
Bills of Quantities for Electrical Installation Works
Item
Description
Qty
Unit
6
No.
Sub total B/F fro the previous page
A
Cable manager
B
Cat 6 UTP 4-pair cable as Siemons or approved equivalent 12,240 M
.
3M RJ45-RJ45 Cat 6 UTP factory terminated patch cord as 120
No.
Siemons or approved equivalent to be used at work station.
C
D
E
F
G
RJ45 Cat 6 UTP (Dual) outlet complete with faceplate and
labeling system as Siemons or approved equivalent.
Active Components
48 port CISCO Switch, as described in particular
specifications.
250mm x 50mm deep two compartment metal
trunking constructed from heavy gauge powder coated
steel, and shall be complete with all accessories for 2
coupling and earthing including all trunking accessories.
120
No.
3
No.
200
Lm
Supply, install, test and commission Cisco 7942 unified IP
phone complete with telephone cord and termination block
as described in the technical Specifications section F
20
No.
Total for electrical services
H/8
Rate
Kshs
Cost Kshs