INSTALLATION
INSTRUCTIONS
Accessory
Application
AUTOMATIC
DAY/NIGHT MIRROR
2008 ODYSSEY
PARTS LIST
Automatic Day/Night Mirror Kit
P/N 08V03-S9A-100B
Publications No.
AII 38139
Issue Date
OCT 2007
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Day/Night mirror
Flat-tip screwdriver
8 mm Socket
Owner’s Manual
Isopropyl alcohol
Shop towel
Ratchet
T20 Torx bit
Clip remover
Automatic Day/Night Mirror Attachment Kit
P/N 08V03-SHJ-101
Illustration of the Day/Night Mirror Installed on
the Vehicle
MAIN
HARNESS
Wire cover
DAY/NIGHT
MIRROR
Mirror harness
Subharness
4321081Y
9 Wire ties
INSTALLATION
4 EPT sealers
5 Cushion tapes
Ground bolt
© 2007 American Honda Motor Co., Inc - All Rights Reserved.
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
AII 38139 (0710)
08V03-SHJ-1001-91
1 of 8
3.
Remove the mirror by lifting it up out of the mirror
base.
7.
Remove the two retaining tabs, and remove the
cover from the left sunvisor.
SUNVISOR
HOLDERS
VEHICLE
CONNECTOR
MIRROR
BASE
COVER
RETAINING
TAB
ROOM MIRROR
LEFT
SUNVISOR
4321010Y
2 SCREWS
4.
Remove the right and left map light lenses (four
tabs for each lens).
5.
Remove the two 5 mm bolts and two ground bolts,
and pull out the roof console.
4301191B
8.
Remove the two screws, pull out the left sunvisor,
disconnect the vehicle connector, and remove the
sunvisor.
9.
Repeat steps 7 and 8 to remove the right
sunvisor.
10. Remove the right and left sunvisor holders.
11. Remove the door seal from around the left front
“A” pillar trim. Release the side curtain air bag
clip and remove the left front “A” pillar (two clips).
VEHICLE
CONNECTOR
ROOF
CONSOLE
SIDE CURTAIN
AIR BAG CLIP
4 RETAINING
TABS
4 RETAINING
TABS
DOOR
SEAL
RIGHT MAP
LIGHT LENS
LEFT MAP
LIGHT LENS
LEFT FRONT
“A” PILLAR
TRIM
2 BOLTS,
5 mm
2 GROUND
BOLTS
CLIP
4301182B
4310011B
6.
2 of 8
Disconnect the two vehicle connectors, and
remove the roof console.
12. Remove the right front “A” pillar the same way.
AII 38139 (0710)
© 2007 American Honda Motor Co., Inc - All Rights Reserved.
13. Remove the left front door sill trim (three clips).
LEFT FRONT
DOOR SILL TRIM
17. Open the glove box. Remove the two stoppers by
releasing the two retaining tabs for each stopper.
Remove the glove box damper cover, and remove
the damper rod. Remove the glove box (two
screws).
3 CLIPS
GLOVE
BOX
DAMPER
ROD
GLOVE
BOX
DAMPER
COVER
4301210B
14. Remove the right front door sill trim (three clips).
15. Pull out the door seal at the left kick panel.
Remove the left kick panel (three clips).
3 CLIPS
GLOVE
BOX
DOOR
SEAL
2 SCREWS
2 STOPPERS
2 RETAINING
TABS
7827010Y
LEFT
KICK
PANEL
4301221B
16. Remove the right kick panel the same way (two
clips).
© 2007 American Honda Motor Co., Inc - All Rights Reserved.
AII 38139 (0710)
3 of 8
18. Plug the subharness 7-pin connector into the day/
night mirror.
Routing the Mirror Harness
22. Plug the subharness connector into the mirror
harness connector.
T20 TORX
SCREW
ROOF
CONSOLE
OPENING
SUBHARNESS
CONNECTOR
MIRROR
BASE
SUBHARNESS
7-PIN CONNECTOR
DAY/NIGHT
MIRROR
DAY/NIGHT
MIRROR
MIRROR HARNESS
CONNECTOR
4321020Y
4321040Y
19. Install the day/night mirror to the mirror base.
20. Secure the day/night mirror to the mirror base by
tightening the T20 Torx screw.
21. Route the subharness under the headliner, and
pull it out through the roof console opening.
23. Attach the mirror harness connector to the vehicle
panel with one EPT sealer as far forward as
possible.
NOTE: Do not cover the console bolt hole.
MIRROR HARNESS
CONNECTOR
ROOF
CONSOLE
OPENING
HEADLINER
VEHICLE
PANEL
SUBHARNESS
CONNECTOR
SUBHARNESS
DAY/NIGHT
MIRROR
4321030Y
EPT
SEALER
DAY/NIGHT
MIRROR
4321050Y
4 of 8
AII 38139 (0710)
© 2007 American Honda Motor Co., Inc - All Rights Reserved.
24. Route the terminal from the mirror harness under
the headliner toward the right side of the vehicle.
27. Secure the mirror harness to the vehicle harness
using two wire ties.
ROOF
CONSOLE
OPENING
MIRROR
HARNESS
HEADLINER
RIGHT
FRONT “A”
PILLAR
VEHICLE
HARNESS
GLOVE BOX
OPENING
7827020Y
4321060Y
DASHBOARD
MIRROR
HARNESS
TERMINAL
25. Continue routing the mirror harness down the right
front “A” pillar and behind the dashboard.
2 WIRE
TIES
28. Using isopropyl alcohol on a shop towel, clean the
right front “A” pillar area where the mirror harness
will attach. Attach the mirror harness to the right
front “A” pillar using four cushion tapes.
26. Locate the 22-pin connector below the dashboard
at the kick panel area. Disconnect the vehicle 22pin connector, and insert the mirror harness
terminal into the vehicle 22-pin connector at the
location shown.
RIGHT
FRONT “A”
PILLAR
4 CUSHION
TAPES
MAIN HARNESS
TERMINAL SIDE
MIRROR
HARNESS
TERMINAL SIDE
VEHICLE
22-PIN
CONNECTOR
(View from the harness side)
© 2007 American Honda Motor Co., Inc - All Rights Reserved.
4321221Y
4321202Y
AII 38139 (0710)
5 of 8
29. Using isopropyl alcohol on a shop towel, clean the
headliner area where the mirror harness will
attach. Using scissors, cut two EPT sealers in
half. Using three halves of EPT sealers, attach
the mirror harness to the vehicle panel.
31. Plug the mirror harness 6-pin connector into the 6pin opening in the fuse box.
MIRROR
HARNESS
EPT SEALER
(cut in half.)
MIRROR
HARNESS
6-PIN
CONNECTOR
VEHICLE
PANEL
3 EPT SEALERS
MIRROR
HARNESS
HEADLINER
FUSE
BOX
4321071Y
30. Route the ground terminal end from the mirror
harness along the headliner and down the left
front “A” pillar towards the left fuse box.
ROOF
CONSOLE
OPENING
FUSE BOX 6-PIN
OPENING
4321020B
NOTE: If another accessory is already plugged into the
6-pin connector, remove the dummy connector
from the 6-pin connector taped to the day/night
harness. Plug the 6-pin connector from the
other accessory harness into the 6-pin
connector from the day/night harness you just
unplugged, and plug the day/night harness into
the fuse box.
FUSE BOX
DAY/NIGHT
HARNESS 6-PIN
CONNECTOR
MIRROR HARNESS
DUMMY
CONNECTOR
LEFT
FRONT “A”
PILLAR
OTHER
ACCESSORY
6-PIN CONNECTOR
4319060B
4321010B
6 of 8
AII 38139 (0710)
© 2007 American Honda Motor Co., Inc - All Rights Reserved.
32. Remove the top bolt from the fuel door release.
Attach the ground terminal from the mirror
harness, and reinstall the fuel door release top
bolt using the ground bolt supplied.
35. Along the left front “A” pillar area, secure the
mirror harness to the vehicle harness using four
wire ties.
MIRROR
HARNESS
4 WIRE
TIES
LEFT
FRONT “A”
PILLAR
GROUND
BOLT
VEHICLE
HARNESS
FUSE BOX
VEHICLE
BOLT
(Discard.)
4321060B
MIRROR
HARNESS
GROUND
TERMINAL
FUEL
DOOR
RELEASE
4321040B
33. Secure the mirror harness to the vehicle harness
using two wire ties.
CUSHION TAPE
36. Using scissors, cut one EPT sealer in half. Using
isopropyl alcohol on a shop towel, clean the
headliner area. Secure the mirror harness to the
headliner using three pieces of EPT sealer (one
piece was cut in step 29).
VEHICLE
HARNESS
Half the EPT
sealer from
step 29.
3 EPT
SEALERS
VEHICLE
HARNESS
VEHICLE
PANEL
ROOF
CONSOLE
OPENING
HEADLINER
MIRROR
HARNESS
2 WIRE
TIES
4321070B
7827030Y
34. Using isopropyl alcohol on a shop towel, clean the
vehicle panel. Attach the mirror harness to the
vehicle panel using one cushion tape.
© 2007 American Honda Motor Co., Inc - All Rights Reserved.
AII 38139 (0710)
7 of 8
37. Install the wire cover from the day/night mirror to
the headliner.
38. Reinstall all removed parts.
39. Reconnect the negative cable to the battery.
ROOF
CONSOLE
OPENING
40. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
41. Reset the clock.
42. If equipped check the operation of the satellite
radio according to the vehicle’s Owner’s Manual.
NOTE: Whenever the battery is disconnected, the
driver’s AUTO function is disabled.
SUBHARNESS
DAY/NIGHT
MIRROR
WIRE
COVER
8 of 8
•
Start the engine. Push down on the driver’s
window switch until the window is fully open.
•
Pull up on the driver’s window switch to close
the window completely, then hold the switch
for 2 seconds or more.
•
Test the AUTO window function.
4321080B
AII 38139 (0710)
© 2007 American Honda Motor Co., Inc - All Rights Reserved.