JUMBO BACKDROP BANNER STAND
INSTALLATION GUIDE
1
2
Contents: 2 metal feet, 2 large telescoping
poles, 2 small telescoping poles w/ fixed bolt
at end, & 2 small telescoping poles w/out bolt.
Attach the flat ends of the 2 large poles
to the 2 metal feet using screws.
4
3
Connect 1 small pole w/ fixed bolt to 1
small pole w/out by screwing together.
Repeat with remaining poles. You now
have 2 long poles w/ a nut at each end.
5
Lay the banner out
flat & adjust the poles
to be wider then the
width of the banner.
6
Insert 1 long pole through bottom pole
pocket, now attach this pole horizontaly
to both of the vertical poles w/ the nuts
on either side near the base.
7
Repeat previous step for top of banner &
attach to top holes on the vertical poles.
YOUR JUMB BACKDROP BANNER STAND IS READY TO USE!
ID1177