Directions For Rethreading The Line
push in the two side buttons on the plastic plunger and
1. Gently
slide the plunger forward.
the hidden compartment cap that is located below the base
2. Unscrew
of the rod shaft and remove 1 of the threading weights.
the line to the threading weight and insert the threading weight
3. Tie
through the base of the plunger.
the tip of the rod shaft downwards towards the ground. Pull
4. Tilt
additional line from the reel and allow the weight to travel through
the rod shaft. A little shake of the fishing pole will help.
the weight from the tip of the rod shaft and tie your snap
5. Remove
swivel, lure, hook, or plastic hook to the line. Be sure to put the
threading weight back into the hidden compartment and then screw
on the cap.
the plunger back towards the reel opening until the two side
6. Pull
buttons on the plunger lock back in place.
1 to 2 minutes for rethreading
the line…for hours of
Tangle-Free easy fishing…
Well Worth It!