QUICK’N BRITE INSTRUCTIONS FOR USE
HOW TO MIX QB PASTE OR LIQUID WITH WATER: Just add QB liquid to warm water and shake well. Melt desired amount of QB Paste in microwave or on
stovetop like butter. Add one-cup hot water so QB will melt into a solution, then add remainder of hot water as needed and mix.
LIGHT SOLUTION: 1/8 cup QB to 1-gallon hot water or 1 teaspoon per quart. Shake before each use.
WINDOWS
MIRRORS
GLASS
WINDSHIELD FLUID
ALUMINUM
CHROME
STAINLESS
HEAVY SOLUTION: 2/3 cup QB to 1-gallon hot water or 3 tablespoons per quart. Shake before each use.
FLOORS
ASPHALT
LINOLEUM
BUGS ON WINDSHIELDS
VINYL
ALUMINUM CONCRETE
SIDING
HOLDING TANKS
WOOD
VINYL



WINDOWS, MIRRORS, GLASS: Outside – Wet surface, apply heavy solution with a wet sponge or brush* and hose off. Only apply to cool glass
Inside – spray QB light solution and wipe off. If streaking occurs, solution is too strong. Pour out ¼ of the solution, add hot water and shake to mix.
WINDSHIELD FLUID: In the winter, add 1 cup rubbing alcohol to mixture to prevent freezing.

STEAM CLEANERS OR SHAMPOO MACHINES: For carpets and upholstery, mix 1 cup QB liquid to 5 gallons of water in self contained units, or 2/3 cup to
1 gallon for units that attach to the faucet. Do not add a defoamer or spot remover. For bad stains, apply QB Paste full strength or spray heavy solution on stains
and let sit for a few minutes before shampooing. FOLLOW MACHINE MANUFACTURER’S SPECIFICATIONS. SPOT-CHECK FOR COLORFAST FIRST.

SPOTS ON CARPET / UPHOLSTERY: SPOT-CHECK FOR COLORFAST BEFORE APPLYING QB AND FOLLOW MANUFACTURER’S
SPECIFICATIONS. Apply QB paste full strength to spot with a wet terry cloth in both directions, using a short 5 or 6-inch motion until spot lifts. RINSE
THOROUGHLY. Wipe with a clean wet terry cloth and then with a clean dry terry cloth. QB is guaranteed to remove most stains. EXCEPT: paint, rust
permanent dye, and red or orange Kool-Aid. READ YOUR LABEL, SOME FOOD PRODUCTS HAVE A PERMANENT DYE.

PET STAINS / URINE: Apply QB paste or liquid full strength to area and let sit a few minutes. Follow Spots on Carpet instructions. Repeat process until odor
is eliminated. For urine stains, first apply equal parts white vinegar and water to neutralize odor.

GUM, TAR, CANDLE WAX: Apply QB paste full strength generously to the spot and let sit a few minutes. Scratch the spot lightly towards the center with a
fork or comb on fabrics or a scrub sponge on painted surface. Rub in more QB. Repeat process until the spot lifts from the fabric. RINSE THOROUGHLY.

LEATHER, NAUGHAHYDE, PLASTIC, VINYL, SPORT & LEATHER SHOES: As a rule, ink on leather and naughahyde does not come off. DO NOT USE
ON RAW LEATHER OR SUEDE. TEST LEATHERS FOR COLORFAST AND FOLLOW MANUFACTURER’S SPECIFICATIONS. Apply QB straight or
with heavy solution. Use scrub sponge* and wipe or rinse when done.

SPOTS ON CLOTHES: Wet your fabric and apply QB paste full strength to the stain. Fold material, trapping cleaner and stain between layers of material, then
rub briskly until stain loosens. Put fabric into washer or wipe off with damp terry cloth. For really tough pre-washed stains, mix ¾ cup QB liquid to 1-gallon hot
water and soak over night then wash. WITH ALL FABRICS, CHECK FOR COLORFAST FIRST AND FOLLOW MANUFACTURER’S SPECIFICATIONS.

BATHROOM, FIBERGLASS, TILE, PORCELAIN, MARBLE, GROUT, ETC.: Apply QB paste full strength with a wet scrub sponge. Let sit for 30 to 60
minutes and reapply again with a wet scrub sponge, and then rinse. If bath area is really bad, melt QB like butter and apply hot with a scrub sponge. Let sit 30 to
60 minutes. Reapply with a wet scrub sponge* and rinse. For extremely bad areas, repeat the process if necessary.




DISHWASHER: Use 2 teaspoons QB paste or liquid full strength per load.
WASHING MACHINE: Use ¼ cup QB paste or liquid full strength to full load.
OVEN CLEANING: Apply QB paste directly to oven. Turn oven on LOW for 10-15 minutes. Turn off, allow time to cool, then wipe out.
FLOORS, LINOLEUM, NO-WAX, VINYL, ETC.: Apply QB paste or liquid full strength with a wet scrub sponge* or brush, then wipe off. Or apply heavy
solution with a mop or buffer and rinse or wipe. QB will remove any old wax build-up. For No-Wax floors, use ¼ cup QB liquid to 1-gallon water.

FIREPLACES, BRICK STONE, GLASS DOORS: Apply QB paste or liquid full strength with a very wet stiff brush, or a wet scrub sponge* on glass. Spray
with clear water to rinse and wipe with a terry cloth. QB will remove smoke, soot, creosote and pitch. For extremely bad areas, repeat the process, if necessary.

CONCRETE & ASPHALT DRIVEWAYS: Hose or wet surface (hot water will work faster for heavier grease build-up). Apply QB paste or liquid full strength
to wet surface with a stiff or wire brush. Let it sit 20 to 30 minutes, re-brush, and hose or rinse off. It may be necessary to repeat this procedure in some cases.

AUTO, AIRCRAFT, BOATS, RV’S, SEMIS, TRAILERS, VINYL TOPS, TIRES, CANVAS, LAWN FURNITURE: Apply heavy solution to surface with
scrub sponge* or terry cloth, then hose or rinse off. To remove oxidation and mildew stains, wet the surface and apply QB paste full strength then Rinse
HAND CLEANER, SHAMPOO: Mix 1 part QB liquid to 10 parts hot water. Mixture will thicken slightly when cool and may be poured into a dispenser. As a
shampoo, QB will NOT lather. It will leave fur or hair soft and fluffy with no drying to the skin. Recommended for show animals, livestock or pets.





HARD WATER STAINS AND MINERAL DEPOSITS: With 0000 steel wool wet, apply QB paste from the bucket, generously. Rub it on and let sit for 15
minutes. If it doesn’t come off the first time, repeat the process.
POOLS AND SPAS: Apply QB paste directly with a white webbed sponge and rinse. This can be done with the water in the spa, as it will not harm the pH
balance. FILTERS: Soak in QB heavy solution for one day, then rinse.
BILGES: (For wet bilges) Mix 1 cup QB liquid to 1 gallon of water and pour in bilge’s before leaving the dock. (For dry bilge’s) Use QB heavy solution, spray on
walls of bilge areas and wipe off.
HOLDING TANKS: Dump your holding tanks using lots of water to flush your tanks. Pour one half gallon of QB heavy solution into the toilet bowl. Swish
around a toilet brush to deodorize the bowl. Then release the cleaner into the holding tank. Add some of the solution to the gray water tank also, be sure to put
QUICK ‘ N BRITE in before traveling, so that the cleaner can slosh around in the tanks while driving.
LIKE ANY CLEANING PRODUCTS, KEEP OUT OF CHILDREN’S REACH
*Any white webbed scrub sponge for tubs, teflon, silverstone, etc.; these will not scratch.
Rinse new sponge before using.
If product has been frozen: Product will appear separated. Melt cleaner at LOW temperature until product liquefies and is red in color. (This can be done in small
quantities in the microwave if desired.) Pour QUICK ‘N BRITE into bucket and let cool. Freezing will not cause loss of cleaning ability.