RMS™ Banner Ribbon
3 Rows for 5” Latex Balloons
Subscribe to FREE, “RouseABOUT ” online balloon decorating ideas & instructions:
1
PREPARE
MATRIX
Unfold Matrix
Spray
paint & extra
adhesive if desired.
http:www.rouseinternational.com/ra
Stretch Matrix
Matrix has lite coat
of adhesive.
Correct any twists in
To color Matrix,
spray paint on top of
adhesive, let dry,
then add final coat
of adhesive (3-M
#77 is suggested).
the Matrix as you go.
Discard pop out chips.
TIP: Many paints are brittle when dry and will crack off the Matrix when the plastic is bent. Test paint before use.
If some cuts in
the Matrix resist
opening, flex
them back and
forth and pull
them open.
Area that should
open
Bend down on both
sides
Bend up on both
sides.
Pull apart.
NOTE: If you need other sizes in these shapes, ask your distributor about Custom Made Rouse Matrix Designs.
“Car rier Tabs”
“Connector Tabs”
facilitate handling.
are used to join one Ribbon
section to another.
Cut or tear them off at the joint
before loading balloons.
1
2
Simply insert one tab end
through the heart shaped
opening in a matching tab.
You will recognize the joints
by the tiny (0.05”) connection.
3
TIP: The best balloon inflation size can vary depending on softness and slickness of balloons. Test for best results.
Size balloons
to 4”.
2
For very neat results
tie most balloons in
very tight pairs and
trim off excess
balloon necks.
For faster completion
of your project, tie
most balloons far
apart and skip triming step.
PREPARE
BALLOONS
Inflate &
squeeze balloons
Visit our web site at http://RouseInternational.com for photos and more decorating products and decorating ideas.
3
LOAD
BALLOONS
Roll balloons into
place with the dark
spot on the tops of
the balloons pressed
against the Matrix
and the necks of
both balloons
pressed against the
strap between the
balloons.
Equal portions of
each balloon should
be above and below
the Matrix straps.
Ask your distributor about other Rouse Products to make ballooning more fun, more effective, and more profitable.
Ribbons may be hung vertically, draped horizontally
or bent into bows. The shape to the right is a popular
form to remind viewers of special causes when balloons
are loaded in specific colors and patterns.
USA Patents #6,332,823 & #7,094,124. Other patents pending.
File: S-RIB3-BNR-51A-5L-INSTR
Updated: 3/9/2007
© G. Rouse 2007 - Rouse International, Columbia, SC,File:
USAMP-BLDR-H-50A-11L-INSTR
- Email: [email protected]
USA Patents #6,332,823 & #7,094,124. Other patents pending.
Updated: 9/3/2006