Storage
Solutions
2300 Bethards Drive, Suite S
Santa Rosa, California 95405
Fishing
Enthusiast
for
the
888.654.8281
Assembly Instructions
WFR-012 Tackle Trolley
www.orgfishing.com
TM
1. Lay out all parts and components on a flat surface.
2. With arrow pointing up and side by side, attach 2 plastic holders (2) to the end of the lower tube with locking wheel (4). Slide up or
down until it clicks, making. sure that the ridge inside the plastic holder (2) fits in the indent around the tube (4)
3. Repeat step 2 on the other lower tube with locking wheel (4) and the 2 lower tubes with non-locking wheels (5). Make sure that all plastic
holders (2) are at the same height on all four lower tubes.
4. With the shelf apron facing down, slide a shelf (6) down over the four lower tubes (4 & 5). By pressing down on the shelf make sure that
the shelf (6) sits balanced and firmly on top of the plastic holders (2)
5. Screw the upper tubes (3) in to the top of the lower tubes (4 & 5).
6. By repeating step 2, attach 2 plastic holders (2) to each tube at the desired location for the second shelf. Slide up or down until it clicks,
making sure that the ridge inside the plastic holder (2) fits in the indent around the tube (4) It is recommended that the second shelf is at
least one foot above the bottom shelf. Make sure that all plastic holders (2) are at the same height on all four tubes.
7. With the shelf apron facing down, slide a shelf (6) down the lower tubes (3, 4 & 5). By pressing down on the shelf make sure that the
shelf (6) sits balanced and firmly on top of the plastic holders (2).
8. Repeat steps 6 & 7 for the third shelf (6)
9. With the hooks on the back of the rod butt holder (8) slide the rod butt holder down on to the wire apron at the narrow side of the
bottom shelf (6). Repeat for the other rod butt holder on the opposite side of the bottom shelf.
10. With the hooks on the back of the rod tip holder (1) slide the rod tip holder down on to the wire apron at the narrow side of the
top shelf (6). Repeat for the other rod tip holder on the opposite side of the top shelf. Slide rubber clips along rod tip holder for desired
spacing between rods.
11. Reducing or increasing the distance between the rod tip holders (1) and the rod butt holders (8) can be made by attaching either
holder to a different shelf and/or by adjusting the height of the shelves. You can find appropriate distances between the rod tip and rod
butt holders for all sizes of fishing rods.
12. Apply the peg hooks (7) to the front of the shelves.
13. Please make sure that the locking wheels (4) are unlocked when you want to move the unit.
This product is not designed to hold a total weight of more than 150 pounds. Please distribute the weight on the shelves evenly for
best results.