Onyx Series – Auto Load Adjust User Guide INTRODUCTION The Onyx vibration isolation table is designed to isolate sensitive equipment from vibrations caused by foot traffic, HVAC systems, nearby operating machinery, etc. It consists of a stainlesssteel tabletop supported by four pneumatic isolators, which are easily inflated using a hand pump or other air source. When properly inflated, these isolators will reduce the transmission of vibrations to the tabletop, providing a vibration-free work surface for sensitive equipment. INSTALLATION PROCEDURES 1. Place the Onyx vibration isolation table on a flat and level surface. Be sure the surface can safely support the weight of both the Onyx and the equipment to be placed on it. 2. Place equipment on the Onyx so that the weight is balanced and evenly distributed. 3. Attach the 6mm tubing coming out of the back of the Onyx to the outlet side of the air regulator. The outlet side is marked out. 4. Use the supplied 6mm tubing to connect the inlet on supplied regulator to a supply of compressed air. IMPORTANT: The air supply should not exceed 70 psi (0.5 MPa, 5 kg/cm2), 5. Once the air supply is connected, begin to increase the pressure into the Onyx by lifting the cap on the regulator and slowly turning the knob clockwise. IMPORTANT: Do not exceed 70 psi (0.5 MPa, 5 kg/cm2), maximum operating pressure. Allow 10-15 seconds for the Onyx’s leveling to stabilize. The leveling valves will raise the Onyx so that it is “floating” approximately 2.3” 6. If you experience rocking, decrease the back pressure by turning the knob on the regulator counterclockwise. 7. Lock the pressure adjustment knob by pushing it down. 8. The height was pre-adjusted at the factory, but if you need to adjust height you can do so by adjusting the bolt attached to the lever arm. This may need to be done outside of the enclosure. Adjust bolt to control height. General Specifications Model Number Dimensions (In./mm) Table Weight (Lbs/Kg) Max. Load Capacity (Lbs/Kg) Natural Frequency (Hz) Onyx – 6A Onyx – 7A Onyx – 8A L 16 x D 17 x H 2.3 in. L 20 x D 24 x H 2.3 in. L 32 x D 24 x H 2.3 in (406 X 531 X 58 mm) (508 x 609 x 58 mm) (812 x 609 x 58 mm) 47 Lbs (21.3 Kg) 77 Lbs (35 Kg) 110 Lbs (50 Kg) 150 Lbs 150 Lbs 200 Lbs Vertical: less than 2.5 at max. load Horizontal: less than 2.5 at max. load
© Copyright 2024 Paperzz