WELCOME TO NMU
PRINTABLE GRAD PARTY FAVORS
NMU SUNGLASSES
1. Cut along the dotted line.
2. Tape the flaps at the edge of glasses to
the grey flaps at the edge of the temple
piece. See 2.5 for visual aid.
2.5.
#SHARENMU
#SHARENMU
1.1
#SHARENMU
#SHARENMU
1.2
NMU BOWTIE
1. Cut along the dotted line.
2. Poke holes through the two pairs
of white holes.
3. Run string or a rubberband through the back
of one hole and then through the front of its
pair. Bring it around threw the back and do the
same for the other pair of dots, then tie off
around the neck. See 3.5 for visual aid.
3.5.
#SHARE
NMU
#SHARE
NMU
2.1
NMU MEDALLION
1. Cut along the dotted line.
2. Poke holes through the pair of white holes.
3. Poke one end of string through each hole ≠≠and
tie off to create a medallion.
3.5.
3.1
1. Cut out shape following all green
dotted lines around the perimeter.
NMU WILDCAT WILLY MASK
4.1
2. Cut out dotted green lines that make the
eye holes of the mask.
3. Attach a popsicle behind one side of
Willy’s moustache or tie a rubber band
around the backside of Willy’s head.
NMU 3D STANDING “N”
1. Cut out “N” shape following all green
dotted lines around the perimeter.
2. Fold all white dotted lines at the base of
the “N” to make the stand and back rest.
See 2.5 for visual aid.
2.5.
5.1
5.2
5.3
5.4
5.5
5.6--
NMU 3D HANGING MOBILE
2. Fold triangle tab down in center of the “N”
to help keep the two N’s perpendicular.
3. Connect the two “N” shapes by sliding the
them together by the vertical cut in the
middle of the two shapes.
4. Hang these 3D mobiles by central hook
shape located on the green “N” or let
them stand alone.
NORTHERN MICHIGAN UNIVERSITY
1. Cut out “N” shape following all dotted lines
6.1
6.2
6.3
6.4
6.5
6.6
NORTHERN MICHIGAN UNIVERSITY
STANDING LOGOS
1. Cut out the logo shape following
all dotted lines.
2. Fold yellow tabs inward to support the logo.
7.1
7.2
7.3
NMU TORCH
1. Cut along the dotted line.
2. Bend back the two white flaps so that
they overlap.
3. Tape together two white flaps along
overlapped edge to create handle.
3.5.
Overlap
and tape
Back
view
Side
view
8.1
NMU BEARD
1. Cut along the dotted line.
2. Poke holes through the two pairs
of white holes.
3. Run one end the string through one of the white
holes and tie it off. Do the same with the other
end, tying off once you have adjusted around
your head. Loop string over ears to keep
supported. See 3.5 for visual aid.
3.5.
9.1