I.
FEATURES WITH DIAGRAM
1. Direct Memories (M1~M12)
4.Line Jack
2. Set Key
5.Phone jack
3. Number Keys (0,1~9,*,#)
ITGS-450 Photo Dialer
Manual
Features:
- Large, easy to see, one-touch push buttons (12 buttons).
- This one-touch photo dialer can store up to 12 telephone numbers.
Each number can be up to 16 digits long.
- This photo dialer has a keypad on the bottom, which is covered by a pullout door.
This keypad is used to set the telephone numbers for each picture.
II. OPERATION
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the
1) Installation
following two conditions: (1) This device may not cause harmful interference, and (2)
On the top of the photo dialer unit, there are 2 sockets - “line” and “phone.”
this device must accept any interference received, including interference that may
Connect your telephone line cord (not included) into the “line” socket. Connect the
cause undesired operation.
supplied phone cord into the “phone” socket and your telephone (no included).
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
2) Pictures
NOTE: This equipment has been tested and found to comply with the limits for Class B
1) Place the supplied symbols in the desired positions (if applicable).
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
2) Place your pictures in the desired locations.
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
3) Programming the 12 photo buttons (photo buttons are not pre-set)
installed and used in accordance with the instructions, may cause harmful interference
1) Pick up your telephone receiver and place temporarily on table.
to radio or television reception, which can be determined by turning the equipment
2) Turn over the photo dialer and pullout the protective door.
off and on, the user is encouraged to try to correct the interference by one or more
3) Press the “set” button
of the following measures:
4) Enter the appropriate phone number
-Reorient or relocate the receiving antenna.
5) Press the appropriate photo button (on front of unit) to save the number.
-Increase the separation between the equipment and the receiver.
6) Repeat these steps 3-5 to program all 12 buttons.
-Connect the equipment into an outlet on a circuit different from that to which the
7) Once completed, put back the telephone receiver.
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
4) How to use your photo dialer
1) Pick up your telephone receiver.
CALIFORNIA PROP 65 WARNING
2) Press the photo key you want, and the telephone dials the number automatically.
"WARNING" This product contains a chemicals known to the State of California to
cause birth defects or other reproductive harm. For more information on these
Special note regarding the stored numbers:
Please note that as long as this photo dialer is connected to an active phone line, the
stored phone numbers in the photo keys will be retained indefinitely. However, if the
phone line become damaged or is disconnected, this may result in memory loss. In this
case, you will have to re-program the photo keys with your phone numbers.
regulations and a list of chemicals, log on the following website address :
http://www.oehha.ca.gov/prop65.html
Customer Information
7. If the telephone company requests information on what equipment is connected to
their lines, inform them of:
1. This equipment complies with Part 68 of the FCC rules and the requirements
a)
The telephone number that this unit is connected to,
adopted by the ACTA. On bottom of this equipment is a label that contains, among
b)
The ringer equivalence number REN 0.2B
other information, a product identifier of US:8YMKX02BITGS450 . If requested,
c)
The USOC jack required [RJ11C], and
this number must be provided to the telephone company.
d)
The FCC Registration Number US:8YMKX02B ITGS450
2. If this equipment ITGS-450 Photo Dialer causes harm to the telephone network,
Items (b) and (d) are indicated on the label. The ringer equivalence number (REN)
the telephone company will notify you in advance that temporary discontinuance of
is used to determine how many devices can be connected to your telephone line.
service may be required. But if advance notice isn’t practical, the telephone
In most areas, the sum of the RENs of all devices on any one line should not
company will notify the customer as soon as possible. Also, you will be advised of
exceed five (5.0). If too many devices are attached, they may not ring properly.
your right to file a complaint with the FCC if you believe it is necessary.
3. The telephone company may make changes in this facilities, equipment,
operations or procedures that could affect the operation of the equipment. If this
happens the telephone company will provide advance notice in order for you to
make necessary modification to maintain uninterrupted service.
4. If you experience trouble with this equipment, you disconnect it from the network
until the problem has been corrected or until you are sure that the equipment is not
malfunctioning.
5. Please follow instructions for repairing if any (e.g. battery replacement section);
otherwise do not alternate or repair any parts of device except specified.
6. Connection to party line service is subject to state tariffs. Contact the state public
utility commission public service commission or corporation commission for
information.
Innovative Technology Electronics Corp.
Please include your check or money order in the amount of
Limited Warranty: 90 Days Labor, One Year Parts
• USD$5.00 for items $10.00 to $39.99 (Price Paid Per Unit)
• USD$10.00 for items $40.00 to $99.99. (Price Paid Per Unit)
Innovative Technology Electronics Corp. (IT) warrants the product to be free from
• USD$16.00, for items $100.00 and up. (Price Paid Per Unit)
“Defects” in materials under normal use for a period of “One Year” from the date of the
• Shipping fees are non-refundable
original purchase. The Warranty is “Not” transferable. IT agrees, within the initial “90
to be payable to Innovative Technology Electronics Corp.(for handling and return
Day” period, to repair or replace the product if it is determined to be defective at “No
shipping charges) (IT) will not be responsible for delays or unprocessed claims
Charge”. It is further agreed that IT will cover the cost to repair or replace damaged
resulting from a purchaser’s failure to provide any / all of the necessary information.
“Parts” only for a total period of “One Year” from the date of the original purchase. The
Send all inquiries or RMA request via our website www.ithomeproducts.com/support.
warranty does not cover cosmetic damage, antennas, AC cords, cabinets, headbands,
Innovative Technology Electronics Corp.
ear-pads, or damage due to line power surges, connection to improper voltage supply
1 Channel Drive
or settings, misuse, mishandling, accident, acts of God or attempted repair by an
Port Washington, NY 11050
unauthorized service agent.
Toll free: 1-877-483-2497
Website for support: www.ithomeproducts.com/support
To obtain service, the purchaser MUST present an original sales receipt / proof
of purchase. Please contact us at www.ithomeproducts.com to request an RMA
There are no express warranties except as listed above.
(Return Material Authorization) number to return products for service or
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE
replacement.
EXCLUSIVE REMEDY OF THE CUSTOMER, (IT) SHALL NOT BE LIABLE FOR ANY
Returns without an RMA number on the package will be refused and
returned to sender. Upon receipt of the returning item and our full inspection (IT) may
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS
issue a replacement to customer for the same item or of one that has equivalent value
OR IMPLIED WARRANTY ON THIS PRODUCT EXCEPT TO THE EXTENT
and features. To return an item, supply full name, return address, phone number, item
PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF
purchased, receipt of purchase and reason for return to obtain RMA number.
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS
PRODUCT IS LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY.
All returns must be in the original packaging or reasonable substitute to prevent
Some states do not allow the exclusion or limitation of incidental or consequential
damage.
damages, or limitations on how long an implied warranty lasts, so the above exclusions
Customer “Must” include full name, shipping address and telephone number inside of
or limitations may not apply to you. This warranty gives you specific legal rights and
package. No return will be shipped back to a PO Box or APO address.
you may also have other rights, which vary from state to state.