WRA-LSL-X01-LX
LATTICE STACKING X-CUBE
ASSEMBLY INSTRUCTIONS
WRA-LSL-X01-LX
PAGE 1
WRA-LSL-X01-LX
LATTICE STACKING X-CUBE
PARTS LIST:
1. Attach the side ladders to the bottom stabilizers using(6) of
the 1-1/4” screws through the pilot holes.
° Side ladders (2)
° Diamond “X” assembly
2. Secure the top stabilizers using (6) of the 1-1/4" screws
through the pilot holes.
° Top & bottom stabilizers (6)
° 1-1/4" screws (16)
TOOLS REQUIRED:
* Utility knife
* Cordless drill or Phillips head screwdriver
PAGE 2
WRA-LSL-X01-LX
3. Assemble the diamond “X” assembly and place it on the
inside of the cube as indicated.
B) Slide the diamond center strips into the case frame, making
sure it fits snug.
NOTE: The fit must be snug so the “X” assembly does not slide out.
A) Take the “X” assembly
and slide the grooves into
place.
NOTE: If it does not fit snug, turn it around and slide it back in.
PAGE 3