Chlorine dioxide
analyzer
series
M 1054 C
• on-line free chlorine measurement
• PI regulation included
• galvanicaly separated current outputs
• easy assembling and managment
• IP 65 housing
General:
Chlorine dioxide analyzer type M 1054 C is designed for measurement and control in drinking
water, waste water treatment and swimming-pools applications.
The unit consists of two electrodes (platinum and copper - measurement electrodes)
measurement cell with mechanical cleaning and microprocessor controlled unit with graphic
display. With clear measured signal control unit evaluates and amplifies cell current and with an
automatic temperature compensation we have an accurate measured signal on the output and on
the graphical display shown in mg/l.
Control unit can be equipped with PI regulator output or with galvanically separated
4-20 mA signal on the amplifier output.
User can easily communicate with control unit over graphic display and four keys.
All this guarantees accurate and continuous measurement and regulation.
Mesuring and regulation equipment / Sensors / Chlorine residual analyser
Mesuring and regulation equipment / Sensors / Chlorine residual analyser
Analyser drawing:
Order codes :
M 1054C/
F - Flow
S - Reference
Measuring range
1 - 0-1 mgClO2/l
2 - 0-2 mgClO2/l
x - on request
R - Regulator included
D - Communication output - Selecan
C - Current output sensor (4 - 20 mA)
A - Automatic temperature
compensation
Technical data :
Measuring range (M.R.)
Measured value resolution
Deviation of indication, measured value
pH range
Automatic temperature compensation range
Regulator
Electrical data :
Supply voltage
Power
Isolation voltage
Current output connector:
Moduls
Current range
Load
Output range
Output Mode
Regulator connector:
Outputs
Inputs
Mode
General data :
Ambient temperature
Relative humidity
Control unit protection
Dimensions
Weight
Data is subject to change without notice.
0 - 2 mg/l
0,001 mg/l
maximum 2% of M.R.
6.5...8
0...+50ºC
3 point or PI regulator
24 VAC±20%
5 W Maximum
500V (to analog part)
2
4...20 mA
maximum 600 E
adjustable to (M.R.)
Selectable
- ClO2 signal output
- Temperature
- Regulator output
3 x 24 VAC / 250 mA
3 x 24 VAC
Selectable
- Motor Control
- Pump Control
-10...+50ºC
10...95 % non-condensating
IP 65
698 x 336 x 105
4,3 kg
Fajfarjeva 15, 1230 Domzale,
Slovenija
Tel. +386 1 72 13 552,
Fax +386 1 72 19 360
www.controlmatik-abw.si