Assembly Instructions
GEO
TV STAND
STOP!
Before you start...
2
1
Read Instructions carefully.
Lay out all of the components on a soft surface
as if you were preparing to do a jigsaw puzzle.
3
Carefully identify each component, especially
those that are similar. The most common mistake
is getting things back to front.
Separate and identify each component from the
hardware pack and rest each one in its proper
location before fastening.
5
6
DO NOT over-tighten screws
DO NOT set glue until you are certain that the
parts belong together.
Page 2
What You Need
Top panel
(P2)
2 x Side panel
(P1)
1 xDivider
(P4)
(tools not provided)
Phillips Head Srewdriver
Flat Head Screwdriver
Mallet
Shelf
(P5)
(P1)
Base panel
(P3)
1 x allen key
6 x Short
Dowels
(H1)
8 x Long
Dowels
(H2)
16 x Screws
(H5)
6 x Allen
Bolts
(H6)
6 x Cam
Bolts
(H3)
2 x Brake
Wheel
(H7)
6 x Cam
Nuts
(H4)
2 X Wheel
(H8)
Page 3
Step 1
(H3)
You will need:
6 x Cam
Bolts
(H3)
(P2)
Screw cam bolts (H3) into the top panel (P2).
Step 2
You will need:
(H1)
6 x Short
Dowels
(H1)
(P4)
(P5)
(H1)
(P2)
Conect the shelf (P5) to the panels (P2) and (P4) using short dowels (H1). Insert
the short dowels (H1) to the dowel holes on panel (P4).
Page 4
Step 3
You will need:
8 x Long
Dowels
(H2)
(H2)
(P4)
(P1)
(H2)
(H2)
(P1)
(P2)
(H2)
Insert the long dowels (H2) into the two top of side panels (P1), then cover the top panel to it.
Step 4
(H6)
(H6)
You will need:
(H6)
6 x Cam
Nuts
(H4)
6 x Allen
Bolts
(H6)
(P3)
(P1)
(H4)
(P4)
(P1)
(H4)
Insert the cam nuts (H4) into the shelves (P1) and (P4). Rotate the cam nuts so the arrows point
towards the incoming cam bolts, then push the side panels (P1) into place and tighten the cam nuts.
Screw the base panel (P3) to the panels (P1),(P2) and (P4) using the allen bolts (H6) .
Page 5
Step 5
You will need:
(H8)
16 x Screws
(H5)
2 x Brake
Wheel
(H7)
2 X Wheel
(H8)
(H7)
(P3)
(H8)
(H7)
Align each wheel with the 4 pilot holes in the base panel (P3). Place the two brake wheels (H7) nearest
to the front of the unit. Screw the wheels (H8) into place with the screws (H5) .
Step 6
The job is now complete!
In the interest of our environment
Please dispose of all packaging thoughtfully.
Page 6