Step 4: Install handles and apply silicone
2042E/2042TE
INSTALLATION MANUAL
A).Install door handles;
B).Apply silicone along wall jambs and bottom rail, only out side;
C).Apply silicone along the wall jamb inside of the shower doors.
Remark: The shower doors can only be used after 24 hours.
C
B
A
ST3.5x35
9/ "×13/ "
8
64
M4x18
5/ "×45/ "
64
32
Dear customer, should you have any questions,
please contact your distributor immediately; for
more information, please visit our
website: www.acritec.com
Maintenance tip:
The following substances or articles may cause physical
harm and/or damage the shower door.
Do not use them for cleaning.
Acid and alkaline solvents, chemicals such as hydrochloric
acid, acetone thinner, solvents, cleansers, or polishers,
nylon brooms or sandpaper.
7
hardware
2X
1X
5
6
6X
12
1X
1X
7
8
9
8X
12X ST3.9x20
2X ST3.9x12
5
25
5
15
/32"× /32"
13
/32"× /32"
14
6X
6X
15
10X ST3.5x35
9
3
/64"×1 /8"
10
11
4X
8X M4x18
45
5
16
17
18
1X
1X
15
16
/32"× /64"
6X
spare parts
2X ST3.5x35
1X
9
3
1X
/64"×1 /8"
11
10
1X
M4x18
5/ "×45/ "
32
64
17
12
1X
13
ST3.9x20
5/ "×25/ "
32
32
1X
14
ST3.9x12
5/ "×15/ "
32
32
1X
18
illustration of components
1
2042E/2042TE COMPONENTS
1
2
3
4
5
6
7
8
9
2 wall jambs
2 door panels
1 top rail
1 bottom rail
2 sets of TB handle
1 left end block
1 middle block
1 right end block
6 buffers
10
11
12
13
14
15
16
17
18
3
4
5
*Installed
6 caps for buffers
10 ST3.5X35(9/64"×13/8")screws
6 anchors
12 ST3.9X20(5/32"×25/32")screws
2 ST3.9X12(5/32"×15/32")screws
8 caps of screws
4 safe nail
8 M4X18(5/32"× 45/64") screws
6 φ4(5/32")washers
Note: Because of the requirement of customer, the top rail could be different.
1
2
hardware
2X
1X
5
6
6X
12
1X
1X
7
8
9
8X
12X ST3.9x20
2X ST3.9x12
5
25
5
15
/32"× /32"
13
/32"× /32"
14
6X
6X
15
10X ST3.5x35
9
3
/64"×1 /8"
10
11
4X
8X M4x18
45
5
16
17
18
1X
1X
15
16
/32"× /64"
6X
spare parts
2X ST3.5x35
1X
9
3
1X
/64"×1 /8"
11
10
1X
M4x18
5/ "×45/ "
32
64
17
12
1X
13
ST3.9x20
5/ "×25/ "
32
32
1X
14
ST3.9x12
5/ "×15/ "
32
32
1X
18
illustration of components
1
2042E/2042TE COMPONENTS
1
2
3
4
5
6
7
8
9
2 wall jambs
2 door panels
1 top rail
1 bottom rail
2 sets of TB handle
1 left end block
1 middle block
1 right end block
6 buffers
10
11
12
13
14
15
16
17
18
3
4
5
*Installed
6 caps for buffers
10 ST3.5X35(9/64"×13/8")screws
6 anchors
12 ST3.9X20(5/32"×25/32")screws
2 ST3.9X12(5/32"×15/32")screws
8 caps of screws
4 safe nail
8 M4X18(5/32"× 45/64") screws
6 φ4(5/32")washers
Note: Because of the requirement of customer, the top rail could be different.
1
2
Step 1: Install bottom rail and wall jambs
A).Insert left end block, middle block and right end block into the bottom rail, place the bottom rail
on the middle the bath tub edges;
B).Fix left end block using one screw and leave the hole on the wall side free. In the same way, fix the
right end block;
C).Place the wall jamb on the wall vertically, cover the end block. Mark the drill position;
D).Drill φ6mm(15/64") holes and insert anchors;
E).Use ST3.5X35(9/64"X1 3/8") screw to fasten the wall jamb,use ST3.9X20(5/32"X25/32")
screw to fasten the buffer;
F).Connect wall jamb and bottom rail using screws;
G).Cover the buffer caps.
A
ST3.5x35
9/ "×13/ "
64
8
B
ST3.9x20
5/ "×25/ "
32
32
C
ST3.9x20
5/ "×25/ "
32
32
ST3.9x20
5/ "×25/ "
32
32
E
F
D
6mm
15/ "
64
G
3
4
Step 1: Install bottom rail and wall jambs
A).Insert left end block, middle block and right end block into the bottom rail, place the bottom rail
on the middle the bath tub edges;
B).Fix left end block using one screw and leave the hole on the wall side free. In the same way, fix the
right end block;
C).Place the wall jamb on the wall vertically, cover the end block. Mark the drill position;
D).Drill φ6mm(15/64") holes and insert anchors;
E).Use ST3.5X35(9/64"X1 3/8") screw to fasten the wall jamb,use ST3.9X20(5/32"X25/32")
screw to fasten the buffer;
F).Connect wall jamb and bottom rail using screws;
G).Cover the buffer caps.
A
ST3.5x35
9/ "×13/ "
64
8
B
ST3.9x20
5/ "×25/ "
32
32
C
ST3.9x20
5/ "×25/ "
32
32
ST3.9x20
5/ "×25/ "
32
32
E
F
D
6mm
15/ "
64
G
3
4
Step 2: Install top rail
step 3: Install door panels
A).Install the top rail from up side;
B).Through the pre-drilled holes in the top rail, drill φ3.2 mm(1/8") holes in wall jambs;
C).Connect top rail and wall jambs using ST3.9X12(5/32"X15/32") screws. Cover the caps.
A.Slide the middle block to side and hang up inner door panel;
B).Slide inner side panel to side but don't reach middle block. Install out door panel;
C).Install safe nails;
D).Slide middle bolck to the middle of the bottom rail, keep both door panels into the slots of the middle
block. Secure the block using 2 screws.
A
outside
ST3.9x12
5/ "×15/ "
32
32
A
C
B
A
B
A
C
ST3.9x20
5/ "×25/ "
32
32
D
5
6
Step 2: Install top rail
step 3: Install door panels
A).Install the top rail from up side;
B).Through the pre-drilled holes in the top rail, drill φ3.2 mm(1/8") holes in wall jambs;
C).Connect top rail and wall jambs using ST3.9X12(5/32"X15/32") screws. Cover the caps.
A.Slide the middle block to side and hang up inner door panel;
B).Slide inner side panel to side but don't reach middle block. Install out door panel;
C).Install safe nails;
D).Slide middle bolck to the middle of the bottom rail, keep both door panels into the slots of the middle
block. Secure the block using 2 screws.
A
outside
ST3.9x12
5/ "×15/ "
32
32
A
C
B
A
B
A
C
ST3.9x20
5/ "×25/ "
32
32
D
5
6
Step 4: Install handles and apply silicone
2042E/2042TE
INSTALLATION MANUAL
A).Install door handles;
B).Apply silicone along wall jambs and bottom rail, only out side;
C).Apply silicone along the wall jamb inside of the shower doors.
Remark: The shower doors can only be used after 24 hours.
C
B
A
ST3.5x35
9/ "×13/ "
8
64
M4x18
5/ "×45/ "
64
32
Dear customer, should you have any questions,
please contact your distributor immediately; for
more information, please visit our
website: www.acritec.com
Maintenance tip:
The following substances or articles may cause physical
harm and/or damage the shower door.
Do not use them for cleaning.
Acid and alkaline solvents, chemicals such as hydrochloric
acid, acetone thinner, solvents, cleansers, or polishers,
nylon brooms or sandpaper.
7