Molar Volume Lab Grading Rubric

Molar Volume Lab Grading Rubric
NAME: _________________________________ DATE: __________ CLASS: _______
TITLE & PURPOSE
2 PTS: ________
HYPOTHESIS
2 PTS: ________
PRELAB ASSIGNMENT:
(Be sure to show all work and all units.)
6 PTS: ________
1. a. STP
b. Water Vapor Pressure
c. Dalton’s Law of Partial pressure
2. Mass of 8.95 cm of Mg
4 PTS: ________
3. # of moles in 8.95 cm of Mg
4 PTS: ________
4. Volume at STP
5 PTS: ________
5. Balanced Equation
4 PTS: ________
PROCEDURE
10 PTS: ________
ORIGINAL SIGNED DATA TABLE
10 PTS: ________
PROCESSING THE DATA
a. pressure of dry hydrogen
2 PTS: ________
b. volume of hydrogen at STP
8 PTS: ________
c. number of moles of Mg and
number of moles of hydrogen gas produced
8 PTS: ________
d. molar volume
5 PTS: ________
e. percent error
5 PTS: ________
DISCUSSION & CONCLUSION
15 PTS: ________
Be sure to include all possible sources of error, actual
error or problems, result reliability, how you would change, what
you learned, as well as a brief description of the chemistry required
to determine molar volume. (Stoichiometry, moles, Boyle’s law etc.)
LAB SAFETY/CLEAN UP EFFORT
10 PTS: ________
TOTAL
100 PTS: ________
MOLAR VOLUME LAB
PRE-LAB ASSIGNMENT
1. The following terms are pertinent to the laboratory exercise. Look them up. Study
them and define them:
a. STP- _________________________________________________________________
________________________________________________________________________
b. Water Vapor Pressure- ___________________________________________________
________________________________________________________________________
c. Dalton’s Law of Partial Pressure - __________________________________________
________________________________________________________________________
2. The mass of 1.000 ± 0.005 meters of magnesium ribbon is 0.98 ± 0.01 g. What would
be the mass, in grams, of a 8.95 ± 0.05 cm piece of magnesium? Include all units and sig.
figs.
3. How many moles of magnesium are there in 8.95 ± 0.05 cm of ribbon?
** 1 meter of Magnesium ribbon = 1448 grams
4. If the gas has a volume of 85.6 ± 0.1 mL at 25.2 ºC and 98.5 kPa what would the
volume be at STP?
5. Write the balanced equation for the reaction between magnesium metal and
hydrochloric acid.
Vapor Pressure of Water
Temperature
Pressure
Temperature
Pressure
(degrees C)
0
(mmHg)
4.6
(degrees C)
50
(mmHg)
92.5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
4.9
5.3
5.7
6.1
6.5
7
7.5
8
8.6
9.2
9.8
10.5
11.2
12
12.8
13.6
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
97.2
102.1
107.2
112.5
118
123.8
129.8
136.1
142.6
149.4
156.4
163.8
171.4
179.3
187.5
196.1
17
18
14.5
15.5
67
68
205
214.2
19
20
21
22
23
16.5
17.5
18.7
19.8
21.1
69
70
71
72
73
223.7
233.7
243.9
254.6
265.7
24
25
26
22.4
23.8
25.2
74
75
76
277.2
289.1
301.4
27
26.7
77
314.1
28
28.3
78
327.3
29
30
79
341
30
31.8
80
355.1
31
33.7
81
369.7
32
35.7
82
384.9
33
37.7
83
400.6
34
39.9
84
416.8
35
42.2
85
433.6
36
44.6
86
450.9
37
47.1
87
468.7
38
49.7
88
487.1
39
52.4
89
506.1
40
55.3
90
525.8
41
58.3
91
546
42
61.5
92
567
43
64.8
93
588.6
44
68.3
94
610.9
45
71.9
95
633.9
46
75.7
96
657.6
47
79.6
97
682.1
48
83.7
98
707.3
49
88
99
733.2
100
760
MOLAR VOLUME LAB
Our intent in assigning this laboratory exercise is to give you the opportunity to
produce, collect, and measure a gas. The gas will by hydrogen and it will be produced by
reacting magnesium metal with hydrochloric acid, HCl. The other product, zinc chloride,
does not interfere with our investigation.
You will measure the volume of the hydrogen produced under the conditions
currently in the lab. You must also take into account the water vapor pressure at the
temperature of the lab. You will then convert the volume from lab, conditions to STP.
From the length of magnesium ribbon and the balanced equation you should be
able to calculate number of moles of hydrogen gas produced. Knowing this value and the
volume of hydrogen gas produced at STP you can calculate the volume of one mole of
hydrogen gas at STP. The actual molar volume of ANY gas at STP is 22.4 Liters.
PROCEDURE:
Partner #1:
1. Obtain a strip of magnesium from your teacher. The gas collecting tube, hydrometer
jar, thermometer, copper wire, ruler, two-hole rubber stopper, and hydrochloric acid
should be at your lab station. Measure the length of the magnesium strip to the nearest ±
0.05 cm. Roll it into a little ball and wrap it with the thin copper wire. Leave enough of a
tail on the wire to be able to extend through the stopper.
PARTNER #2.
1. Place the hydrometer jar in the sink. With a beaker from your lab drawer fill the
hydrometer jar with tap water. Notice that the gas collecting tube is calibrated. Using the
tube as a measure pour in, very carefully, 10.0 mL of 6.00 M (Molar) hydrochloric acid.
The hydrochloric acid is quite concentrated and must be handled with care. If you
get any on you or your clothing notify your teacher at once. KEEP THE LAB
GOGGLES ON AT ALL TIMES. Tilt the gas collecting tube to one side and carefully
and quickly pour tap water into the tube until it is full to the very top. The level of the
water should be above the graduations. Insert the stopper and magnesium into the tube.
Place your thumb over the stopper, invert the tube, and quickly place the tube into the
hydrometer jar. Let it rest on the bottom. Record your observations.
When the reaction is complete shake the tube to free the gas bubbles from the side of the
tube. Raise the tube until the liquid levels inside and outside the tube are equal. Read the
volume of the gas from the scale on the gas collecting tube to the nearest ± 0.1 mL. When
the levels are equal the pressure inside and outside the tube are equal. Record the outside
pressure, the barometer pressure. Take the temperature of the water in the hydrometer jar.
This is also the temperature of the gas.
Empty all containers into the sink and flush with water. Do not leave any solid materials
in the sink.
DATA TABLE:
The data table should include length of ribbon, temperature of gas, volume of gas,
barometric pressure, water vapor pressure at lab conditions, and the mass of one meter of
magnesium ribbon.
PROCESSING THE DATA:
Include all calculations with units and proper number of sig. figs.
Calculate:
a. the pressure of dry hydrogen gas.
b. the volume of hydrogen gas at STP. (remember you know it for lab conditions only)
c. the number of moles of magnesium. Why is this also the number of moles of hydrogen
gas?
d. the molar volume of hydrogen gas.
e. percent error.