Max Burton® Spotlight 2.5M Candle Power #6990
Cordless & Rechargeable
IMPORTANT SAFEGUARDS
•
•
•
•
•
•
•
Read all instructions before operating
Lens becomes very hot during operation. Handle carefully and do not store until
it cools completely.
Do not shine directly into eyes
Do not immerse cord or unit in water or other liquids
Unit may be operated in wet environments
Do not let cord hang over the edge of table or counter
Administer close supervision when using this spotlight around children
2 POSITION
HANDLE
HANDLE RELEASE
BUTTON
ADJUSTABLE
BASE
Not Shown:
12V DC adapter & 120V AC/DC adapter
DC INPUT
•
•
•
For optimal performance, fully charge battery prior to first use and each
subsequent recharge using either of the included adapters.
Before charging, make sure the power switch is in the OFF position.
Time required to fully charge the battery is about 20 hours.
To ensure the unit is fully charged and ready for use, it may be left connected to
the chargers, even after a full charge has been achieved.
120V AC/DC Charging:
1. Plug the AC/DC adapter into the DC Input on the spotlight and the other end
into an electrical wall outlet
2. A green charging indicator light on the adapter will illuminate to indicate it is
charging and remain on during charging
3. A red charging indicator light will illuminate when the battery is fully charged and
will remain on until the unit is unplugged or the battery has fallen below a fully
charged level
Operation
RED
FLASHING
BEACON
3 POSITION
POWER SWITCH
•
12-volt DC Charging:
1. Plug the DC adapter into the DC input on the spotlight and the other end into
the DC power receptacle in your vehicle
2. To prevent the vehicle battery from overloading, it is recommended that the
vehicle’s engine remain running during charging
3. There are no charging indicator lights on the DC adapter. Allow 20 hours to fully
charge the battery
PARTS IDENTIFICATION
HALOGEN
SPOTLIGHT
BULB & LENS
CHARGING
1. Push the handle release button to turn the 2 position handle to
either the upper position (pistol grip) or lower position (search grip). The upper
position is for spotlighting long-range objects. The lower position is ideal for
search mode.
2. The Adjustable Base may be positioned at different angles for ground level
or tabletop use
3. The 3 position power Switch will select either the spotlight or flashing
beacon operation:
• Spotlight (―) position
• Red flashing beacon (=) position
• Off (Ο) position
CANDLE POWER
SPECIFICATIONS
2.5 Million
Input: 120V 60 Hz 4.5VA
Output: 7.2V DC 300 mA
AC/DC ADAPTER
DC CAR ADAPTER
FUSE: BATTERY COMPARTMENT
BULB
BATTERY
POWER DURATION
WEIGHT
DIMENSIONS
Input: DC 12V
Output: DC 7.5V 300 mA
15A standard blade fuse
H3 6V55W halogen bulb
Rechargeable 6V 4Ah sealed lead
acid
Fully charged:
20 minutes for spotlight
100 hours for flashing beacon
3.85 lbs
9 1/2” L x 6 1/2” W x 7 1/4” H
ATHENA BRANDS
An Aervoe Industries, Inc. Company
Gardnerville, NV 89410 • 1-800-272-8603
www.athenabrands.com • [email protected]
6990inst; cs3/09
Spotlight 2.5M Candle Power
Cordless & Rechargeable
OPERATING INSTRUCTIONS