Thank you for your purchase of the slackers/ZIPLINE®. This product was engineered to provide safe fun for all ages. For best and safe results, please read instructions carefully when installing and using your slackers/ZIPLINE®. Read and obey all rules. We are sure the this product will provide you with years of fun and enjoyment. Brand 44 Kit Contains: 1) (1) One person Steel Trolley size 11’”x 8” with sealed ball bearings maximize strength while providing smooth operation, Grips with non-­‐slip, notched finish to offer exceptional grip and handling 2) (1) 75 foot, 3/16” steel cable, w/looped eye on one end. 3) (1) 8 foot, 3/16” w/looped eye on each end. 4) (1) Turnbuckle 12” Steel w/Locking hardware 5) (3) 3/16 ” U clamps 6) (1) Instruction book Tools Required : 3/16” wrench and hand pliers (not included), and a helper. BE SAFE! -­‐ ALWAYS FOLLOW THESE RULES •
•
•
•
•
•
•
•
Adult supervision is required at all times. Wear a Helmet. Make sure everything is installed correctly and check for wear before using. If worn or damaged parts are found, contact Brand 44 for replacement parts -­‐ Do not substitute with other, non-­‐Brand 44 parts or failure resulting in injury could result. Wait until you have stopped COMPLETELY before letting go of the trolley. One rider only at a time. Wear close fitting clothing, NO scarves or other loose clothing Keep people at least 25 ft. away from the zipline course when in use. Never use the line when it is wet or if there is rain or lightning in the area. FAILURE TO FOLLOW THESE RULES COULD RESULT IN SERIOUS INJURY Brand 44 • 169 Corona Street • Denver Colorado 80218 • 303.339.0482 • www.brand44trading.com CHOOSING THE ZIP LINE COURSE Choose a clear runway for the zip line ride with a sturdy anchor point (a healthy tree 36” circumference or 12” diameter, is recommended or pole or post that can handle at least 1200 LBS) on both ends. Caution: We recommend a grass course underneath that is clear of ALL obstacles: bushes, rocks, or anything else that could cause injury. If the grass course becomes hard-­‐packed over time, move course to a softer location. CABLE ATTACHMENT HEIGHT GUIDELINE Attachment height is from the ground up: SEE TABLE BELOW. Attachment height for ride start for 70 ft. course 114 Inches 120 Inches 126 Inches 132 Inches 138 Inches Rider’s Height 48 Inches 54 Inches 60 Inches 66 Inches 72 Inches Attachment height for ride start for 60 ft. course 108 Inches 114 Inches 120 Inches 126 Inches 132 Inches Attachment height for ride start for 50 ft. course 102 Inches 108 Inches 114 Inches 120 Inches 126 Inches Attachment height for ride finish 78 Inches 84 Inches 90 Inches 96 Inches 102 Inches X.3 CONSUMER INFORMATION SHEET FOR PLAYGROUND SURFACING MATERIALS11 X3.1 The U.S. Consumer Product Safety Commission (CPSC) estimates TABLE X3.1 Fall Height In Feet From Which a Life Threatening that about 100,000 playground equipment related injuries resulting from Injury Would Not Be Expected falls to the ground surface are treated annually in U.S. hospital emergency Type of Material 6 in deep 9 in deep 12 in. deep rooms. Injuries involving this hazard pattern ten to be among the most Double Shredded Bark Mulch 6 10 11 serious of all playground injuries, and have the potential to be fatal, Wood Chips 6 7 12 particularly when the injury is to the head. The surface under and around 5 6 9 playground equipment can be a major factor in determining the injury-­‐Fine Sand Fine G
ravel 6 7 10 causing potential of a fall. It is self evident that a fall onto a shock absorbing surface is less likely to cause a serious injury that a fall onto a hard surface. Playground equipment should never be placed on hard materials if they are installed and maintained at depths of 6,9 and 12 surfaces such as concrete or asphalt and while grass may appear to be inches However, it should be recognized that all injuries due to falls acceptable it may quickly turn to hard packed earth in areas of high traffic. cannot be prevented no matter what surfacing material is used. Shredded bark mulch, wood chips, fine sand or fine gravel are considered X3.3 It is recommended that a shock absorbing material should extend to to be acceptable shock absorbing surfaces when installed and maintained a minimum of 6 Feet in all directions from the perimeter of stationary at a sufficient depth under and around playground equipment. equipment such as climbers and slides. However, because children may X3.2 Table X3.1 lists the maximum height from which a child would not deliberately jump from a moving swing, the shock absorbing material be expected to sustain a life-­‐threatening head injury in a fall onto four should extend in the front and rear of a swing a minimum distance of 2 different loose-­‐fill surfacing times the height of the pivot point measured from a point directly beneath the pivot on the supporting structure. 11This information has been extracted from the CPSC X3.4 This information is intended to assist in comparing the relative shock-­‐absorbing properties of various materials. No particular material is publications “Playground Surfacing – Technical Information recommended over another. However, each material is only effective when Guide” and “Handbook for Public Playground Safety.” Copies of properly maintained. Materials should be checked periodically and these reports can be obtained by sending a postcard to the replenished to maintain correct depth as determined necessary for your Office of Public Affairs, U.S. Consumer Product Safety equipment. The choice of a material depends on the type and height of the Commission, Washington, D.C., 20207 or call the toll-­‐free hotline: 1-­‐800-­‐638-­‐2772 playground equipment, the availability of the material in your area and its cost. Extreme Backyard Adventures 2 Installation Step 1: The 8 foot sling cable is wrapped around your attachment for ride start point (Figure 2)and connected to the main zipline cable using the turnbuckle (Figure 3). You should have the turnbuckle fully extended at this point (Figure 4). Step 2: Thread the cable, using the blunt end of the cable, through the pulley (Figure 5), between the wheels and the handlebar. Make sure the trolley frame is pointing down hill. START POINT FINISH POINT Figure 2 Figure 3 Figure 1 Step 3: This step requires two people. Pull the cable tightly around the finish point tree/pole and complete the loop using your three cable clamps, spaced about 2-­‐3 inches apart. The zipline wire goes on the bottom of the clamp, then place the end length on top of the zipline wire and then the U-­‐shaped part of the clamp goes on top of the end length. When wrapping the cable around the finish attachment point, you should form an “tear-­‐drop” shaped loop around the finish tree or pole. DO NOT form a tight circle around the finish tree/pole, as this will cause premature wear and stress on the components. Tighten the clamp nuts to approx. 3 foot pounds of torque. (figure 6) Figure 4 Figure 5 Step 4: Tune the zip line by tightening the turnbuckle, which will tighten up the line. (See figure 1 above) Figure 6 Note: After the first rider has used the zipline, re-­‐torque the clamps as a precaution against loosening. Step 5: Launching Platform (figure 7)-­‐ Must be stable and not prone to rocking. Should be tall enough to allow your shortest riders to easily reach the trolley. Figure 7 Extreme Backyard Adventures 3 Final Tune-­‐up Before putting your zip line into action, do a full weight test. Start by first measuring the distance from the ground to the hand trolley with the trolley at the mid-­‐point in the line. Then hang approx. 200 LBS from the trolley and then re-­‐measure the distance from the ground to the trolley. The distance should be approx. 4 inches closer to the ground. If its less, loosen the turnbuckle, if its more than 4 inches, tighten the turnbuckle. Failure to do this can result in injury ü Check and retighten all clamps as necessary. ü Cover exposed wire end (by the clamps) with electrical or duct Figure 8 tape to prevent injury. ü Test the speed to ensure that all riders will be able to stop before reaching the end. ü Check for and prevent cable slippage on your anchors. ü Check the runway for obstacles, like branches, rocks, anything that might scratch, cut or hurt someone. ü Walk the entire length of the zipline course. Remember, installing and operating your zip line safely is your responsibility! Establishing a safe operating procedure is essential. Children should be taught how to ride the zip line safely including wearing a helmet, and should be supervised at all times. Enjoy the Zip line, and have a great adventure! Extreme Backyard Adventures 4