Weather Balloon Inflator

Weather Balloon Inflator
Assembly
Push the brass barbs on the nozzle/regulator into the ends of the inflation hose. Do not push the barbs all the way
into the hose. This step is best performed while holding the end of the hose firmly in one hand while pushing the
nozzle/regulator barb into the end of the hose with your other hand while simultaneously rotating the
nozzle/regulator clockwise.
Trim the ends of the included line with a pair of sharp scissors and melt the tips with a lighter to prevent the ends
of the line from fraying. Tie a loop in one end of the line and tie the other end of the line around the nozzle barb
just above the inflation hose. You can now hook your launch scale to the loop to measure your balloon’s lift.
Important
Make sure the neck of your balloon is securely attached to the inflation nozzle before using the included launch
scale to measure lift. Wrap electrical tape around the neck of the balloon and bottom of the inflation nozzle to
secure the balloon to the inflation nozzle. Failing to do so will cause the balloon to slide off the inflation nozzle and
float away.
To accurately measure lift, make sure there is slack in the inflation hose. The inflation nozzle and hose weigh 250 g.
Therefore, you will want to add 250 g to the measurement on the scale when measuring lift.