Fitting rear LED lights
After taking out old lights see two holes level with each other inside the cup holders
shown here
Take the rubber rings from the old lights and fit to new cups.
Push the new cup in place and mark with felt tip,
like this
and like this
Drill these marks out using size 5 bit then take these screws from the old lights,
and fit them to the back of the new cups like this
and screw back into place, like this
Then onto the centres the lights themselves:
shown here
You will have to source screws to fit them together as they are not supplied with the lights.
this shows the centre unit screwed in place
Just on the inner part of the cup there is a lip superglue this and push the lights into place, make
sure that the Hella sign is straight up, and that's it the wiring is really easy,
All lights off
Indicator
Brakes
Side lights
Reverse
Fog light
Note that there is no colour showing through these lights as colourless bulbs were used so they all
look the same when off in the daytime like this
Whole job, start to finish, takes about 3hrs