XR TIME SYNCHORNIZATION
XR CLASSIC SERIES DIGITAL CLOCK/TIMER - REMOTE ANTENNA INSTALLATION
Materials Supplied
Ref.
Description
1
Connector with solder terminals
2
Cable 4.5 meters (15 foot)
3
Remote mounting bracket
4
Screws (2) for mounting bracket
5
Connector
6
Right angle connector
7
Antenna
8
Flat Washer
Figure 1: Remote Antenna Illustration
Additional Cable Accessories
l
5m (16.5’) Cable extension with BNC adapter
Install Remote Antenna
1. Connect one end of cable #2 to connector #5. Push connector on and turn connector 1/4 turn to lock in place.
2. Right angle connector #6 is for horizontal bracket mounting. Remove connector #6 for vertical mounting of bracket.
NOTE: Antenna must be vertical.
3. For vertical mounting, connect antenna #7 to the other end of connector #5. For horizontal mounting, connect antenna #7 to right
angle connector #6.
4. Use two screws (Items #4) to secure bracket #3.
Antenna BNC Cable
The clocks/timers with a remote antenna are shipped from the factory with the 4.5 meters (15 foot) BNC cable attached to the clock/timer
assembly.
Doc Part No.: Q12487 08.12.14
l
l
l
l
The length of the 4.5 meters (15 feet) cable can be increased by adding cables and adaptors up to a maximum
recommended length of 13.7 meters (45 feet). The cable can be placed in any position, but the antenna must be mounted
vertically and away from metal objects. Unless it is very close to the transmitter, the powered clock will not set to the
correct time without the remote antenna connected.
If the remote antenna is to be mounted several centimeters above the clock, and if the antenna cable is to be concealed
behind the wall, use a single gang electrical box to be mounted horizontally behind the clock. For a straight vertical cable
run, a minimum 1.27cm (.5“) electrical conduit should be used, coupled with the top side of the electrical box.
If 5m (16.5’) cable extension(s) is to be used, and the intent is to keep as much cable concealed as possible, connect the
extension(s) to the standard 4.5 meters (15’) antenna cable prior to running the cable into the conduit.
For a concealed cable run, a half-inch hole in the wall will need to be made close to where the remote antenna bracket
will be mounted. The antenna cable BNC plug has a straight vertical mate with the remote antenna bracket.
Primex Wireless
XR Classic Series Digital Clock/Timer - Remote Antenna Installation
2
PRIMEX WIRELESS LOCATIONS
Worldwide Headquarters
965 Wells Street
Lake Geneva, WI 53147
Phone: (855) 557-0337
Hours: 7:00 AM to 5:00 PM CST
[email protected]
UK Office
Unit G420 Dean Clough
Halifax, West Yorkshire HX3 5AX
Phone: 0800-3896996
Hours: 8:30 AM to 5:00 PM
[email protected]
SUPPORT
Contact Technical Support
Available Monday through Friday, 7 AM to 7 PM CST (excluding holidays)
To reach our support team, call 1-800-404-8112, and press:
Option 1: 72MHz/GPS Clock Systems, Transmitters and Bell Systems
Option 2: SNS Network-based Clocks, Bells, Sensors and Software
Option 3: OneVue Software, Sensors, Clocks, and Bell Scheduling
Option 4: Primex Wireless Customer Service
Primex Wireless
XR Classic Series Digital Clock/Timer - Remote Antenna Installation
3