Neutralization and Dilution Tanks 6 Gal. “Milk Jug”
“Milk Jug” tanks are specifically designed for under the bench use where large flows are anticipated. When
used without limestone chips the tanks serve as a dilution basin. When used with limestone the tank
serves as point-of-use neutralization tank. The tanks come equipped with spin off cap for easy access and
maintenance. The image below shows the tank with the optional installation kit and waste. (ALL DIMENSIONS IN INCHES)
A1
A2
If vent is required please use
these part numbers
W32510-150
W32510-200
X1
X
B1
B2
B
A
D
G
K
E
A3
L
Part #
CAPACITY
(US Gal)
A
A1 A2
A3
B
B1
B2
X1
NPT
USABLE
X2
CAPACITY
VENT (US Gal.)
E
G
L
K
13-1/2"
2"
12-1/2"
16"
1/4"
1-1/2" 1-1/2" 1-1/2" 4.3
16" 13-1/2"
2"
12-1/2"
16"
1/4"
2"
W32505-150
6
12" 8"
5-1/2" 11"
18-1/2" 17-3/4" 16"
W32505-200
6
12"
5-1/2" 11"
18-1/2" 17-3/4"
8"
X
MPT
D
2"
2"
4.25
WT.
(LBS.)
8
8
CONNECTING ADAPTER
W59201-150
INSTALLATION KITS
For W32505-150 USE
W38525-150 And For
W32505-200 Please
use W38525-151
5" ACID WASTE PIPE
W59306-150
STREET ELBOW
W59206-150
SLIP RING
1.5 NUT
REDUCER
W51554-201
MODIFIED W51554-150
TRIMMED TO FIT / 1.5 NPT
TAPERED
GASKET
Tanks should be of seamless construction, rotationally molded in the USA. From HD polyethylene resin conforming to ASTM D-1998-06
and ASTM D-4976. External fittings conforming to ASTM F-1412, shall be polyfused and/or welded to the tank, and be provided with
the inlet dip pipe extending down to the bottom. The effluent must be discharged at the bottom of the tank to maximize dwell time.
Covers are either bolted down or welded to the tank. The inside bottom of the tank shall be flat with no recessed areas where acid
waste or other contaminants can pool.