Printable ring sizer
Please note you MUST PRINT this chart (it will not work if you try to measure directly on screen). Prior to printing, please ensure the
page size is set to ‘Actual size’ or ‘100%’ in your print dialog box. Use a ruler to check that the ring sizer is exactly 10cm long on your
printed page. This chart represents ring sizes for Australia. Sizings are approximations only and actual rings produced using these sizing
methods may require adjustment at Metal Urges.
Method one Wrap around ring sizer
1
2
3
4
5
Cut around ring sizer outline.
Use a utility knife to cut a slit in the ring sizer
where shown.
Wrap the ring sizer around the appropriate finger
with the letters on the outside.
Poke the pointed end of the sizer through the slit
and pull so it fits snugly around the widest part of
your finger (normally at the largest knuckle).
Read the letter size (E-Z) at the slit. If the size falls
between two letters, use the larger size.
Cut slit
here
INST R U CTIONS
E G I K M O Q S U W Y Z+1 Z+3
F H J L N P R T V X Z Z+2
10cm
Cut slit
here
E G I K M O Q S U W Y
F H J L N P R T V XZ
Printable ring sizer
Method two Current ring sizer
10cm
INST R U CTIONS
1 Choose one of your current rings that comfortably fits the correct finger.
2 Place your ring over the circles below until you find the best match. The circle should match the INSIDE of your ring.
3 Use the letter inside the circle that matches.
E
13.7mm
F
G
14.1mm
O
P
17.5mm
17.9mm
W
X
20.8mm
H
14.5mm
21.2mm
14.9mm
I
J
15.3mm
15.5mm
K
15.9mm
L
16.7mm
Q
R
S
T
U
18.3mm
18.7mm
19.2mm
19.6mm
20mm
Y
Z
21.6mm
Z+1
21.8mm
22.4mm
F
G
H
I
J
K
V
Z+2
Z+3
22.8mm
L
17.1mm
20.4mm
23mm
Want to know more? Visit www.metalurges.com.au or email [email protected]
E
N
M
16.3mm
M