Make N Take Block A
Birthday Class!
6 cards with a case
Supply List:
Stamps: Balloon Adventures
Ink: Calypso Coral, Emerald Envy
Paper: Whisper White, Calypso Coral,
Dazzling Diamonds Glimmer Paper,
Party Animal Designer Series Paper
Embellishments: Thick White Bakers
Twine, Stampin’ Dimensionals, Mini
Glue Dot
Tools: Balloon Bouquet Punch
Directions:
1. Cut the Whisper White cardstock 5 ½ x7”. Cut the Party Animal Designer Series Paper 1 ½
x 7”. Cut Calypso Coral 3 ¼ x 4 ¼”, Cut Whisper White 3 x 4”.
2. Attach the Party Animal Designer Series Paper to the Whisper White. Layer the Calypso
Coral in the center.
3. On the Whisper White stamp the balloon strings in Emerald Envy Ink. Stamp the balloons in
Emerald Envy and Calypso Coral, and also stamp the sentiment banner with the same
inks.
4. Punch out the stamped balloons with the Balloon Bouquet Punch and punch out an
additional balloon with Dazzling Diamonds Glimmer Paper. Pop the Glimmer Paper
balloon up with Stampin’ Dimensionals as well as the banner.
5. Make a bow out of Thick White Bakers Twine and attach it with a Mini Glue Dot.
Supply List:
Stamps: Balloon Adventures
Ink: Pacific Point
Paper: Whisper White, Pacific Point,
Party Animal Designer Series Paper
Embellishments: Staple, Stampin’
Dimensionals, Emerald Envy 1/8”
Taffeta Ribbon, White Pom Pom Trim
Tools: Big Shot, Layering Ovals
Framelits, Triple Banner Punch
Directions:
1. Use Whisper White Note Cards. Cut Pacific Point 3 ¼ x 4 ¾”, Cut the Party Animal
Designer Series Paper 1 ½ x 4” and cut another 1 x 4 ¾”.
2. Use the Triple Banner Punch and make the Designer Series Paper pieces Banners and then
layer onto the Pacific Point.
3. Wrap around the Emerald Envy Ribbon and tie.
4. Take a piece of the White Pom Pom Trim and loop if over the Emerald Envy Ribbon and
staple.
5. Stamp the sentiment in Pacific Point Ink and cut out in the Big Shot with the Layering Ovals
Framelits. Attach to the card with a Stampin’ Dimensionals.
Supply List:
Stamps: Balloon Adventures
Ink: Soft Suede
Paper: Whisper White,
Blushing Bride, Dazzling
Diamonds Glimmer Paper,
Party Animal Designer Series
Paper
Embellishments: Burlap
Ribbon, Wink of Stella Clear,
Stampin’ Dimensionals, Mini
Glue Dot
Tools: Balloon Bouquet
Punch, Triple Banner Punch
Directions:
1. Use a Whisper White Notecard. Then cut Blushing Bride 4 ¾ x 3 ¼”. Cut the Party Animal
Designer Series Paper 4 ½ x 3”. Layer them onto the card.
2. Cut Whisper White ½ x 3” and then stamp the sentiment in Soft Suede Ink. Use the Triple
Banner Punch and then attach to the card.
3. Punch out a balloon in Dazzling Diamonds Glimmer Paper and attach.
4. Stamp the other balloon onto Blushing Bride with Soft Suede Ink and then punch out. Use
a Stampin’ Dimensional to attach.
5. Make two bows with Burlap Ribbon threads and attach to the balloons with a Mini Glue
Dot
6. Embellish the stamped balloon with Wink of Stella Clear.
Supply List:
Stamps: Balloon Adventures
Ink: Smoky Slate
Paper: Whisper White,
Crushed Curry, Dazzling
Diamonds Glimmer Paper,
Party Animal Designer Series
Paper
Embellishments: Basic
Rhinestones, Stampin’
Dimensionals, Mini Glue Dot
Tools: Big Shot, Layering
Circles Framelits, 2 Inch
Circle Punch
Directions:
1.
2.
3.
4.
5.
Start with the White Note card. Then cut Smoky Slate 4 ¾ x 3 ¼”, Cut the Party Animal
Designer Series Paper 4 ½ x 3. Layer these onto the notecard.
Cut Dazzling Diamonds Glimmer Paper ½ x 3 ¾” and then make the ends banners.
Stamp the sentiment in Smoky Slate onto Whisper White cardstock. Then punch out with
the 2” Circle Punch. Layer this onto a scallop circle that is cut out of the Big Shot in
Crushed Curry with the Layering Circles Framelits.
Attach to the card with Stampin’ Dimensionals.
Embellish by sprinkling Basic Rhinestones.
Supply List:
Stamps: Balloon Adventures
Ink: Calypso Coral, Pacific
Point
Paper: Whisper White,
Calypso Coral, Pacific Point,
Party Animal Designer Series
Paper
Embellishments: White Pom
Pom Trim, Stampin’
Dimensionals, Mini Glue
Dots, Basic Rhinestones
Tools: Balloon Bouquet
Punch, Chalk Marker
Directions:
1. Start out with a White Notecard. Then cut the Party Animal Designer Series Paper 5 x 1
¾”, cut Pacific Point 5x2”. Layer these together and then attach to the card.
2. Stamp the sentiment onto the bottom of the card in Calypso Coral Ink.
3. Punch out two balloons, a large one in Calypso Coral and small one in Pacific Point.
Attach them to the card with Stampin’ DImensionals. Stamp the balloon string in
Pacific Point Ink below them.
4. Stamp the banner in Pacific Point Ink and Calypso Coral Ink. Cut out the banner and
attach across the balloons.
5. Embellish with the White Pom Pom Trim across the top with Mini Glue Dots. Then, add
Basic Rhinestones to the banner. Add Highlight marks to the balloons with a Chalk
Marker.
Supply List:
Stamps: Balloon Adventures
Ink: Calypso Coral, Emerald
Envy
Paper: Whisper White,
Tangerine Tango, Emerald
Envy, Party Animal Designer
Series Paper
Embellishments: Emerald
Envy Taffeta Ribbon,
Stampin’ Dimensionals, Mini
Glue Dot, Chalk Marker
Tools: Balloon Bouquet
Punch
Directions:
1. Cut Calypso Coral 4 ¾ x 3 ¼” and attach, cut the Party Animal Designer Series Paper 2 x 4
¾”.
2. Punch out two smaller balloons with Calypso Coral, Emerald Envy Cardstock with the
Balloon Bouquet Punch. Make highlight marks on the balloons with the Chalk Marker.
3. Use the Emerald Envy Taffeta Ribbon and attach to the card with Mini Glue Dots to create
the balloon Strings. Then, Attach the balloons with Stampin’ DImensionals. Tie the Ribbon in
a knot and attach at the bottom of the balloons with a Mini Glue Dots.
4. Stamp the banner onto Whisper White Cardstock with Emerald Envy and Tangerine Tango
Ink. Cut it out and then attach to the card with Stampin’ Dimensionals.
Supply List:
Stamps: Balloon Adventures
Ink: Basic Black, Pool Party
Paper: Whisper White
Embellishments: Black Bakers
Twine, Stampin’
Dimensionals, Mini Glue Dot,
Wink of Stella Clear
Tools: Balloon Bouquet Punch
Directions:
1. Use a White Note Card and stamp the background with Pool Party Ink. Then, stamp the
sentiment in Basic Black Ink.
2. Stamp the balloon in Basic Black and then punch it out with the Balloon Bouquet Punch
and attach to the card with a Stampin’ Dimensional.
3. Make a double bow with the Black Bakers Twine and attach with a Mini Glue Dot.
4. Use the Wink of Stella Clear to color in the sentiment and stripes on the balloon.