NOTES: (UNLESS OTHERWISE SPECIFIED)
REVISION:
(9.750)
1. DRAWING AS PER ASME Y14.5 - 1994.
REV
ECR/ECO
DESCRIPTION
DATE
X1
E0431 INITIAL RELEASE
E0498 ADD PLANE NOTE
X2
E0547 ADD HOLES FOR FANS
X3
X4 E0576X1 CHG HOLE PATTERN FOR 60MM FANS
E0721 MODIFY 8-32 HOLE PATTERN
X5
2. BREAK AND DEBUR ALL SHARP EDGES 0.007 MAXIMUM.
3. MATERIAL: AVVID THERMALLOY PART NUMBER 627251F00000 (GMS 484-009)
06/23/05
10/26/05
02/15/06
04/24/06
02/27/07
DRFT
CHK APPR
SLP
SLP
SLP
SLP
SLP
4. FINISH: LINE GRAIN AND BLACK ANODIZE TO MIL-A-8625F TYPE II CLASS 2
5
REMOVE MINIMUM MATERIAL, AS NECESSARY, TO ACHIEVE THIS FLATNESS
6
USING BEST AVAILABLE METHOD, APPLY GMS PART NUMBER (484-H0719X5)
APPROXIMATELY WHERE SHOWN.
13.5
2.000
0.100
5
2.280
.030
0.750
0.500
4.375
3.875
4.375
3.875
3.772
3.772
0.107
8X
6-32 UNC - 2B
0.506
0.350
0.300
2.694
1.969
1.353
1.969
8.000
12.000 11.500
5.088
7.482
1.969
4.000
1.969
6
9.794
12X
8-32 UNC - 2B
0.328
4X
10-32 UNF - 2B
0.380
TOLERANCES
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES
DO NOT SCALE DRAWING
ANGLE
LINEAR
X.X = +/- 0.2 DEG
X.X = +/- 0.1
X.XX = +/- 0.02
THIRD ANGLE PROJECTION
X.XXX = +/- 0.005
SIZE:
B
GMS INC.
COBHAM SURVIELLANCE
T: (760)496-0055
SCALE:
F: (760)496-0057
WWW.COBHAM.COM/GMS
N/A
DRAWING TITLE:
HEATSINK, MHPT,
13.5 IN
DRAWING:
100-H0719X5
APPROX WEIGHT:
B.O.M.
6.21 LBS
DRAWN BY:
S PHILLIPS
DESIGNER:
S PHILLIPS
CHECKED:
ENGINEER:
O. DE MEYER
SHEET:
1 OF 1
DATE:
06/23/05
DATE:
06/23/05
DATE:
DATE:
REV.
X5