The adventure begins with Setter Play Equipment
Designed in close discussion with head
teachers Chatterbox is a sheltered
meeting place, a place to rest and chat
or even an open air classroom.
Several options available for seating.
2
Chatterbox can be designed to fit most space and size
constraints including square, rectangular, hexagonal
as well as an option designed to fit into corners.
Various roof coverings are available. Weather resistant
bonded felt comes as standard. Optional roof coverings
are felt Shingles for an attractive variation to the standard
felt roll. Feather edged timber is available for a rustic look
and Cedar Shingles for a stylish natural look.
3
Square Bear is the smallest tower in the Setter range
and is designed to fit where space and budget are
tight. The tower is built to the same safety standards
as the Kitemarked Hectors House.
Platform height is 900mm and activities are scramble
net, ramp and rope, vertical ladder and lookout panel.
Scale 1:100
4
Scale 1:100
Hectors House is fully Kitmarked by BSI to EN 1176.
Hectors House is a compact multi-play unit particularly suitable
for infant play areas on village recreation grounds, nurseries
and infant schools.
Activities are a scramble net, fixed vertical ladder, a clamber ramp
with climb rope and a stainless steel slide.
Two platform heights are available at either 900mm or 600mm.
EN 1176
Parts 1 &3
5
Scale 1:100
Zoiks is a triangular tower with a ramp and climb rope
on one face, a scramble net on the another and the third
face has Monkey Bars leading from it (or a ladder down
for the less confident).
Zoiks is designed for use in pre-school or reception
classes. The Monkey Bars present a challenge which
many will progress to, however, initially the rungs can be
used simply for hanging from, which all little ones love.
6
Scale 1:100
Muttley is designed to combine the physical
challenges of Zoiks with the imagination
stimulation of Hectors House. There are three
Platform levels at 600mm, 900mm & 1,200mm.
Muttley is total climbing featuring; ramp and
rope, overhead ladder, scramble net, fixed
vertical ladder and rugs. An option of a long,
stainless steel slide from the 1,200mm
platform is available.
7
Scale 1:100
Top Cat is fully Kitemarked by BSI to EN 1176.
Top Cat features split level platforms with heights at 900mm
and 1,500mm, scramble net, vertical ladder, rope ladder and a
long stainless steel slide.
A rock wall, clamber ramp with climb rope or chunky rung
ladder are available as options.
EN 1176
Parts 1 &3
8
Scale 1:100
Skylark is a two tower unit based on Top Cat featuring
split level platforms on one tower, and a single level on the
other linked by a suspension bridge. Platform heights are
900mm and 1,200mm.
Activities are a vertical ladder, a scramble net, chunky
rung ladder, firemans pole, ramp with climb rope and a
long stainless steel slide.
9
Scale 1:100
Ant Hill is a play unit designed for nursery aged children:
Two triangular platforms to 900mm connected by an
arched bridge. Platforms are reached by simple steps,
a ramp and rope and scramble net. A stainless steel slide
provides a fun means descent.
10
Scale 1:100
Klunk is a two tower play unit for the under six age group with
platforms at 900mm. The towers are linked by an over head
ladder which, at its most basic, is there to dangle from or
more conventionally it is a means of crossing from one tower
to the next. Activities are; simple steps, scramble net, ramp &
rope and slide. Bench seats under the platforms can be
added, as can the Shop counter or 0’s & X’s activity panels.
Roofs are not included on Klunk.
11
Scale 1:100
Click is a two tower play unit for the under six age group, with
platforms at 900mm. Click is more conventional than Klunk as
the two towers are linked by a suspension bridge. In response
to worries of unwelcome ‘visitors’ congregating under the
shelter of play unit roofs out of school hours, Click has roof
frames that provide the stimulus for imagination without the
need for literal roof coverings. This roof design is available on
any of the tower units across the Setter range. Activities are
simple steps, verticle ladder, scramble net & rope. A slide is
not standard on Click but can be added as an option.
12
Scale 1:100
Jellystone is a three tower play unit which
is a combination of Skylark and Zoiks.
The platforms are triangular 900mm
linked by an overhead ladder to a square
900mm platform. The platform levels rise
to 1,200mm, and the two remaining
platforms are linked by a suspension
bridge. Other activities are vertical and
angled scramble nets, chunky rung
ladder, ramp & rope, firemans pole and
stainless steel slide.
13
Scale 1:100
Noggin is a compact multi play unit packed with activities,
including lily pad steps and a barrel shaped climber. The
platform height is 900mm approximately 2.4 x 1.2m wide.
14
Scale 1:100
Spoofum is a compact climbing unit for juniors up to 11
years of age. Platform heights are 1200mm& 1500mm.
With scramble net & chunky rungs to 1200m, rock wall
and firemans pole at the 1500mm deck.
15
Scale 1:100
Pyramid is a challenge for older children,
featuring climbing activities throughout;
unusual wavey rungs, challenging net platform
and tube.
16
Rock Slab is designed to encourage children to traverse
around the equipment as much as climb over it.
The Rock Slab is only 1.7m tall but provides an
absorbing activity for junior ages.
Scale 1:100
Scale 1:100
Monkey Rungs are one of the most popular challenges in any
playground. Children love to see if they have the strength and
stamina to get from start to finish.
17
All drawings to scale 1:100
Model I
A simple, static wooden climber on which children can climb to 1.6m.
Model II
Available with net and log climber, which is slightly
easier than the up and over net, and offers two
angled challenges, maximum height 1.6m.
Model III
Vertical and angled scramble nets similar to
an assault course challenge max 1.6m net.
18
Pugwash is designed to simulate
imaginative play. Parts of the
equipment that are used in play
do not exceed 600mm therefore
safer surfacing is not required.
The equipment is permanently
fixed and can be installed into
either tarmac or grass.
Playbus is designed to be a free
standing, imagination play vehicle.
There are three bench seats for the
driver(s) and passengers. The floor
area is 1,200mm x 2,400mm.
19
A great all rounder
The ever popular Adventure Trail range of equipment
provides a cost effective solution to satisfying the
agility requirements of infants and juniors.
All activities take place below 600mm meaning
that safer surfacing is not required when
situated on grass. All activities are
EN1176 compliment
N
STILTS
K
M
J
L
WOBBLE WALK
SUSPENDED PLANK
STEPPING POSTS
20
TWISTER
A
B
SUSPENSION
BRIDGE
C
SWINGING STEPS
BURMA BRIDGE
D
SPIRAL ROPES
E
CROSSED ROPE
WITH SHIMMY
I
INCLINE BEAM
BALANCE
BEAMS
H
F
CROSSED ROPES
21
All drawings to scale 1:100
D
B
C
A
D
C
E
L
B
A
M
M
K
L
22
K
E
F
F
G
G
H
H
J
I
I
J
23
Custom designs & projects
are undertaken.
Rocking Ramp
Designed for wheelchair accessibility
Easy Acces Steps
Wide steps to enable acces with
either a helper or unaided using
the handrails for support.
Lilypad Steps
Access for nursery & early years children providing
a sure footing on steps surrounded by space.
24
Planters
Planters can be made to any size and
shape, seats can be added as can the
wind chime pergola (in picture).
Playhouse Activity Panels
The Playhouse panels are a trigger for
imagination play. Inside the houses
are activity panels.
Tree seatS
Waterplay
Children can see cause &
effect, by pouring water into
the funnel, which goes down
the trough and into the tank.
The tank is large enough for
childrens toys. A plug is
Sliding Lid Sandbox
provided in the tank.
This large sandbox can accommodate almost a class full
of children at once. It measures 1500mm x 1500mm.
25
Complete
Playgrounds
Swings
Setter swings feature a choice of seat.
Toddler swings have cradle seats whilst junior
swings feature flat seats.
Web Net
Providing a thought provoking challenge.
26
Setter Slide
Stainless steel slides compliant
Setter Roof and
Wall Panels
EN 1176 are used for public play areas.
Panels and roof panels are all
manufactured using CNC technology
from HDPE which is extremely tough
Setter Rope Net
and will not fade in the sun.
Scramble nets are made from
Platforms are made from birch ply with
combination steel multicore ropes and
a bonded phenolic resin coating.
are tested to EN 1176. Ropes are
anchored with welded eye-bolts and
intersected with ball fixings.
Safer Surfacing
Setter can offer wet pour rubber
installed by specialists, loose fill
Timber
materials, impact absorbing grow-
1st Grade timber is machine rounded
through matting or artificial grass with
and pressure impregnated which
or without an impact absorbing layer.
protects against insect and fungal
All surfaces comply with EN 1177.
attack and prolongs timber life.
Machine rounded timbers are
guaranteed against the above
Setter Chain
for 20 years.
Chains used for swings, wobble bridges
and ladders have been fully tested to
confirm with EN 1176. Chains are
Setter Hardware
sheradised to prevent corrosion.
We use stainless or bright zinc plated,
dome headed coach bolts, each
recessed into the wood to protect
Setter Precision
children from scratches and scrapes.
Using computer aided design Setter
Nylock nuts are used and covered with
work to millimetre accuracy ensuring
tamper proof protection caps.
that components fit together on site
with ease, Assembly and maintenance
instructions are provided for self
build projects.
27
59 Royal Oak Lane, Pirton,
Hertfordshire, SG5 3QT, UK
Tel: 01462 713344
Fax: 01462 713534
[email protected]
www.setterplay.co.uk
EN 1176
Parts 1 &3