Product Bulletin
LINK QUALITY™ PLUS
Product Information
Guaranteed Analysis
LINK QUALITY PLUS is a potassium phosphite base material
that contains a fully chelated iron and manganese micronutrient
package. Potassium phosphites have shown to promote plant vigor,
increase turgidity of the plant and rigidity of cell wall strength.
Product Features and Benefits
Total Nitrogen (N)........................................................................... 5.00%
0.50% Ammoniacal Nitrogen
4.50% Urea Nitrogen
Total Phosphoric Acid (P2O5)....................................................20.00%
Soluble Potash (K2O)...................................................................20.00%
•
Contains 20% phosphite (H3PO3) from potassium phosphite to
promote overall plant vigor
•
Potassium phosphite applications have been shown to increase
plant quality during stressful growing conditions
•
Fully chelated iron and manganese for maximum uptake,
availability and tank mix compatibility
•
Tank mix with LINK 17-0-3, 18-0-3 and 12-0-12 to enhance
effectiveness
•
Readily absorbed into the tissue and roots of plants
Iron (Fe)............................................................................................ 0.50%
0.50% Chelated Iron
Manganese (Mn)............................................................................ 0.50%
0.50% Chelated Manganese
Derived from: Potassium Carbonate, Urea, Ammonium
Hydroxide, Potassium Phosphite, Manganese EDTA, and Iron EDTA.
K2O Conversion Rate
Product Application
Turfgrass
Greens and Tees: Apply 1-6 ounces per 1,000 sq. ft. in a minimum of
2 gallons of water. Repeat as needed, allowing a minimum of 14 days
between treatments. Corresponding rates per acre are 1½-8 quarts in a
minimum of 80 gallons of water.
Fairways and Lawns: Apply 1-6 ounces per 1,000 sq. ft. in a minimum of
2 gallons of water. Repeat as needed, allowing a minimum of 14 days
between treatments. Corresponding rates per acre are 1½-8 quarts in a
minimum of 80 gallons of water.
ORNAMENTALS
Foliar Spray Rates:
Herbaceous Plants or Greenhouses: Do not exceed a maximum product
concentration of 0.10% v/v or apply more than 1 quart per acre per
application. Allow at least 1 week between applications. Note: 0.10% v/v
equals approximately 0.25 ounces per 2 gallons of water or 12 ounces
per 100 gallons of water.
Trees and Shrubs or Field-Grown Nursery: Do not exceed a maximum
product concentration of 0.30% v/v or apply more than 2 quarts per
acre per application. Allow at least 1 week between applications. Note:
0.30% v/v equals approximately 0.75 ounces per 2 gallons of water or 38
ounces per 100 gallons of water.
Use as part of a comprehensive Total Nutrition System® for
optimizing plant growth, development, yield and quality. For
more information contact your Wilbur-Ellis nutrition specialist.
ag.wilburellis.com
Pounds of K2O
per 1,000 sq. ft.
Amount of LINK Quality PLUS
to apply per 1,000 sq. ft.
0.10 pound
5.5 ounces
Soil Application Rates:
Transplanting and Establishment of Flowering, Bedding and
Herbaceous Plants: Momentarily submerge the entire seedling tray in a
0.10% v/v solution. Note: 0.10% v/v equals approximately 0.25 ounces of
LINK QUALITY PLUS per 2 gallons of water or 12 ounces per 100 gallons
of water.
Field-Grown Nursery: As an infrequent application, do not exceed a
maximum product concentration of 0.50% v/v. Note: 0.50% v/v equals
approximately 1.25 ounces of LINK QUALITY PLUS per 2 gallons of water
or 64 ounces per 100 gallons of water.
Injection Rates: Apply at a rate of 50-150 ppm of K2O.
PPM OF K2O CONVERSION RATE: For 100 ppm of K2O, prepare a stock
solution by mixing 5 gallons of LINK QUALITY PLUS in 50 gallons of
water and inject stock solution at a ratio of 1:285.
Christmas Trees and Outdoor Plantings of Woody
Ornamentals:
New Plantings and Resets: Once the trees are set in the ground, apply
up to 2 gallons of a 0.50% v/v solution to the root zone of each tree and
1 quart for small shrubs. Make additional foliar applications of 1 quart
per acre at a 2-week spray interval during the growing season. Make
a minimum of 2 foliar applications per season. Note: 0.50% v/v equals
approximately 1.25 ounces of LINK QUALITY PLUS per 2 gallons of water
or 64 ounces per 100 gallons of water.
Maintenance: Make foliar applications of 1 quart per acre at 2-week
spray intervals during the growing season. Make a minimum of 2 foliar
applications per season when plants are actively growing.
952.898.5562
For information only. Not a label. Prior to use, always read and follow the product label directions.
WILBUR-ELLIS Logo, Ideas to Grow With, LINK and Total Nutrition System are registered trademarks,
and LINK Quality is a trademark of Wilbur-Ellis Company. K-0113-031