How to install and how to use WEB LCT console Index 1 2 3 4 5 WEB LCT download WEB LCT installation Adobe Flash Player 9 plugininstallation USB Driver installation Start a connection using WEB LCT 1. WEB LCT (Windows Version) download Enter in http://www.siaemic.com and select Login. Insert userid and password Select Download area, Software and after WEB LCT (Windows Versions) Four options are available: - How to (this document) click to download - WEB LCT Console click to download This operation downloads, or runs, the self extracting file WLC.exe - Adobe Flash Player 9 plugin click to download This operation downloads, or runs, a self extracting file with two Adobe plugin (Flash Player plugin) relevant two Microsoft Windows based browsers: - Internet Explorer the file is Install Flash Player 9 ActiveX.msi - FireFox the file is Install Flash Player 9 Plugin.msi Also the uninstall file will be present. If your browser or Operative System are different, look for proper plugin and install it - USB driver click to download This operation downloads, or runs, the self extracting file USB_drivers.exe 2. WEB LCT Installation Select a different folder, or keep the default one, and push Next> To close the window and run the application push Finish. The software is installed and can be loaded automatically any system start up (if the relevant box is marked): a WebLctConsole tray icon will appear in tray zone. 3. Adobe Flash Player 9 plug-in Installation In case of - Internet Explorer: double click on Install Flash Player 9 ActiveX.msi, click Install and when installation is completed, push Finish - FireFox: double click on Install Flash Player 9 plugin.msi, click Install and when installation is completed, push Finish If desired operation is Repair or Remove, select the proper option 4. USB driver Installation Insert an USB cable on the LCT connector of a working ALC plus. New Hardware found window appears, select the option relevant not access internet and push Next> Select the option relevant the manual path selection and push Next> Browse the path where USB driver has been saved (you have to look for the folder of ErioConnUSBdirect.INF file, then push Next> The installation of Erio connection USB ModemDirect starts and it will be stopped by a message relevant Window Logo test. Push Continue. When installation is over, push End 5. WEB LCT console WEB LCT is the application you need to access ALC plus management. Through an internet browser, a LAN and the IP address of its Ethernet port, the ALC plus can be managed and configured. When LAN is not present a USB serial connection must be used. WEB LCT console is the application that establishes this USB connection and opens the internet browser window necessary to manage it. 1. Connect the PC to ALC plus (LCT connector) through an USB cable 2. Start Web Lct Console by means of a double click over the relevant icon in the tray zone of Windows Application bar 3. Web Lct Console window appears (see Fig. 1) FIG. 1 – siae Web Lct Console main window 4. Before clicking the Connect button, select Options menu 5. The Options window appears (see Fig.2) FIG. 2 – Options window 6. Select Connect using direct serial cable and push Settings see fig.3 FIG. 3 – Modem selection 7. Select the USB connection: Modem – Erio Connection USB ModemDirect , check if the dialling number is 123 and push Configure 8. The Modem Configuration window appears (see Fig.4) FIG. 4 – Configuration of USB Connection 9. All options must be not marked and the Max bit rate must be 230400 bps. Push OK to close the Modem Configuration window 10. Push OK to close the Modem selection window 11. Pusk OK to close Options window. The USB connection is configured properly 12. Push Connect to start the connection towards the ALC plus. The browser will show the WebLct window (see Fig.5) FIG. 5 – WEB LCT
© Copyright 2024 Paperzz
