DRN-XM01C/XM01R/XM01H/XM01CK/XM01HK How to affix the ferrite cores Affixing the ferrite core to the XM antenna You must affix the cores (supplied with the model you purchased) in order to comply with Part 15 of the FCC Rules. Wind the cord around the ferrite core once or twice, and then fasten the catch. Make sure that each ferrite core should be attached to the appropriate position as shown in the diagram below. Wind the cord around the RFC-8 ferrite core once, then fasten the catch. Rubber Approx. 10 mm (13/32 inches) Cord Fasten the catch. Wind once or twice. Affixing the ferrite cores to the RF modulator Wind the cord around the RFC-8 ferrite core once, then fasten the catch. Affixing the ferrite core to the AC power adaptor (AC-E60A) Wind the cord around the RFC-8 ferrite core twice, then fasten the catch. Approx. 10 mm (13/32 inches) Approx. 10 mm (13/32 inches) POWER RFC-8 RFC-8 Wind the black and red cords around the RFC-8 ferrite core twice, then fasten the catch. RFC-8 Approx. 5 mm (7/32 inches) ANT Approx. 10 mm (13/32 inches) Affixing the ferrite core to the car battery cord (DCC-E260) Wind the cord around the RFC-8 ferrite core twice, then fasten the catch. Wind the cord around the RFC-8 ferrite core twice, then fasten the catch. RFC-8 Wind the cord around the RFC-8 ferrite core twice, then fasten the catch. AUDIO RFC-8 DC OUT Approx. 5 mm (7/32 inches) Approx. 5 mm (7/32 inches) Sony Corporation В© 2001 Printed in Japan 3-236-434-12(1)
© Copyright 2024 Paperzz
