FALL-2015 Get solved assignments at nominal price of Rs.125 each. Visit www.instamojo.com/subjects4u search for your code pay and download fully solved assignments. Any issues mail us at: [email protected] or contact at 08894344452 MBA Semester 3 QM0021-Statistical Process Control (Book ID: B1725) Assignment (60 Marks) Note: Answer all questions must be written within 300 to 400 words each. Each Question carries 10 marks 6 X 10=60. Q1. (a) What are the two main causes of variation? Explain. (b) Define the term ‘process’. Give an example of process. Answer. a. Common and special causes are the two distinct origins of variation in a process, as defined in the statistical thinking and methods of Walter A. Shewhart and W. Edwards Deming. Briefly, "common causes", also called Natural patterns, are the usual, historical, quantifiable variation in a system, while "special causes" are unusual, not previously observed, non-quantifiable variation. In manufacturing, quality is defined Q2. (a) What is meant by Standard Deviation? (b) Calculate the standard deviation of the following data, which represents the number of defective products by a machine: 4, 2, 5, 8 and 6. Answer. a. Standard deviation: In statistics, the standard deviation (SD, also represented by the Greek letter sigma σ or s) is a measure that is used to quantify the amount of variation or dispersion of a set of data values. A standard deviation close to 0 indicates that the data points tend to be very close to the mean (also called the expected value) of the set, while a high standard deviation indicates that the data points are spread out over a wider Q3. a) Give the meaning of the following basic terminologies in Probability: i) Sample Space ii) Mutually Exclusive events b) Mention the properties of probability. c) Define the term ‘random variable’. Answer. a. In probability theory, the sample space of an experiment or random trial is the set of all possible outcomes or results of that experiment. A sample space is usually denoted using set notation, and the possible outcomes are listed as elements in the set. It is common to refer to a sample space by the labels S, Ω, or U (for "universal set"). For example, if the experiment is tossing a coin, the sample space is typically the set {head, tail}. For tossing two coins, the Q4. (a) Differentiate between accuracy and precision. (b) Write a brief note on ‘Funnel Experiment’. Answer. Accuracy is defined as, "The ability of a measurement to match the actual value of the quantity being measured". If in reality it is 34.0 F outside and a temperature sensor reads 34.0 F, then than sensor is accurate. Precision is defined as, (1) The ability of a measurement to be consistently reproduced. (2) The number of significant Q5. Define the terms: ‘process capability’ and ‘process stability’. Explain Cp index and Cpk index. Answer. Process Stability refers to the consistency of the process with respect to important process characteristics such as the average value of a key dimension or the variation in that key dimension. If the process behaves consistently over time, then we say that the process is stable or in control. The graphic below illustrates a stable process. The process Q6. Give the meaning of the following: i) Hypothesis testing ii) Control chart iii) Experimental design iv) Acceptance Sampling Answer. i) Hypothesis testing: A statistical hypothesis is a hypothesis that is testable on the basis of observing a process that is modeled via a set of random variables.A statistical hypothesis test is a method of statistical inference. Commonly, two statistical data sets are compared, or a data set obtained by sampling is compared against a synthetic data set from an idealized model. A hypothesis is proposed for the statistical relationship between the two FALL-2015 Get solved assignments at nominal price of Rs.125 each. Visit www.instamojo.com/subjects4u search for your code pay and download fully solved assignments. Any issues mail us at: [email protected] or contact at 08894344452
© Copyright 2024 Paperzz
